Duct Cover Installation
6.Slide the duct cover up and secure the inner duct cover to the telescopic stac (4x8 mm) screws (provided). Refer to Figure 5.
Hood Installation
7.Place temporary screws to hold the duct cover up. Install the hood as shown i
8.Use eight (3/16x3/8 mm) screws (provided) to secure hood to telescopic stack. to tighten screws securely. Refer to Figure 6.
Figure 6
Figure 5
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED. MAKE SURE THIS IS DONE BY SPECIALIZED ELECTRICIAN IN ACCORDANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES. BEFORE CONNECTING WIRES, SWITCH POWER OFF AT SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.
9.Remove the wiring box cover as shown in Figure 7. Remove the knockout from th box.
10.Connect three wires (black, white and green) to house wires and cap with wire
11.Connect according to color. Black to black, white to white, and green to gre
12.Close the wiring box cover and make sure that wires are not pinched between c box.
13.Test the operation of the hood before moving on to next step. Make sure powe to the hood.
6