COMMANDS AND EFFECTS
Overview
The following table gives and overview of all commands and effects. All commands with * can also be used for projection with a single EKTAPRO 7010, 7020, 9010 or 9020 Projector!
Function | Code |
|
|
* Setting dissolve times | 801 - 899 |
(Soft Slide Change in |
|
single projection) |
|
|
|
* Random Access | 0 - 160 |
|
|
Fade (MASTER) | 770 |
|
|
Fade (SLAVE) | 707 |
|
|
Alternate (Crossfading | 777 |
without slide change) |
|
|
|
* Freeze | 789 |
|
|
Independent Projector | 980 |
Control Mode |
|
|
|
Parallel Projection Mode | 970 |
Activate Focus for SLAVE˚ | 666˚ |
|
|
Reactivating of the dissolve | 990 |
mode |
|
|
|
* Remote Security Mode | 989 |
|
|
* Rest | 999 |
|
|
* | 600 - 660 |
|
|
˚ Function is inactivated for |
|
models 7010 and 9010! |
|
Tip
•The last code input via the numerical keypad of the IR remote control remains stored. If the command has to be reinput, it is only necessary to press the <*> key.
•If you input an incorrect figure on the numerical keypad of the IR remote control, press clear <C> before reinputting your figure.
DISSOLVE
Basic setting
After switching on you can immediately begin a dissolve presentation. Dissolving takes place with a default time of 0.5 seconds. As soon as you press the transport forwards button of the remote control both slide trays go to position 1 and the MASTER projector fades the no. 1 slide up at the specified time. If you push the button again the first dissolve happens: slide no. 1 is faded down in the specified time and at the same time slide 2 is automatically faded up. Then the slide tray of the MASTER projector is automatically transported one position further and the projector is ready for the next dissolve. The dissolve process also functions in the same way when you push the transport backwards button.
Notes:
You can interrupt a presentation if the dissolve time is greater than one second. If a dissolve has already started, it can be interrupted by pressing the forward button again at lest 1 sec into the dissolve. The presentation will move on to the next slide. Continuously pressing the forward button will interrupt each dissolve after one second and move on to the next.
Dissolve times with IR remote control
You can input dissolve times of
0 seconds
The numerical combinations of
800 ...899 on your remote control are reserved for this. Please ensure that you press the ENTER button <*> after inputting the relevant combination. Only then is the command received by the projector and the time stored. As soon as you press the transport button on your remote control, the first dissolve takes place.
Examples:
If you want a dissolve time of
1 s :➔ Input <810> and confirm with <*>.
5.5s :➔ Input <855> and confirm with <*>. 0 s (Hard Cut) :➔ Input <800> and confirm with <*>.
Important
The dissolve time you have input is retained until you overwrite it with a new time (via the IR remote control). After a reset (switching off and back on again) the time you have input with the IR remote control is deleted (see Basic setting).
SELECTING SLIDES
As in the case of individual projection, you can transport backwards and forwards at will, or select slides directly (random access). The slide sequence is always retained and the projector which is currently “dark” is automatically carried to the next slide in your presentation.
7
