44 www.kodak.com/go/support
Troubleshooting
Camera ready light statusPicture is too light ■Reposition camera to reduce the amount of available light.
■Turn flash off (page25).
■Move so that the distance between you and the subject is within the
effective flash range (page9).
■To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■Use Auto, Landscape, or Close-up to adjust the exposure
compensation.
Picture is not clear ■To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■Clean the lens (page 58).
■Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■Place the camera on a flat, steady surface or use a tripo d, especially
in high-zoom settings or in low light.
If... Try one or more of the following
Ready light does
not turn on and the
camera does not
work
■Turn on the camera (page2).
■Recharge the battery or install a new one (page1).
■Mode dial was on when battery was reloaded. Turn Mode dial off, then
back on.
Ready light blinks
green
■Picture is being processed and saved to the camera. Camera is
operating normally.
■Camera is connected. Camera is operating normally.
Ready light blinks
red and camera
turns off
■Recharge the battery or install a new one (page1).
If... Try one or more of the following