Installation
1Remove the existing toilet: Turn off the water supply and flush the toilet, then
sponge out all remaining water from the cistern. Disconnect the supply
CAUTION: Risk of hazardous gases. If the new toilet is not installed immediately, temporarity stuff a rag in the closet flange.
2Define the position of connector: Place the connector onto the pan, position between outlet and waste pipe.
Case 1
Connector 
Finished | Case 2 | Finished |
Wall |
| Wall |
Waste Pipe |
| Waste Pipe |
|
| |
180 mm. |
|
|
|
| Connector |
| min. | 90 mm. |
| max. 150 mm. | |
For this model, there are two types of connector. You can choose one of the above pictures which is most suitable to your local plumbing and building codes.
3Position the template on the floor to ensure the rear pan against the wall. Mark the mounting hole centerline on the floor.
Connector to Wall | Connector to Floor |
Kohler Co. | 3 |
