9 GB/IE/CY
J Switch the charger off for at least 15 minutes
between successive charging processes. To do
this pull the mains plug
(
mains adapter 9
)
out
of the socket.
Q Inserting / removing the
battery pack into / out of the
drill / grinder
Inserting the battery pack:
j Set the On / Off switch 1 to position “0”.
j Insert the battery pack 3 into the drill / grinder
until it engages.
Removing the battery pack:
j Pressing the battery pack buttons 2 at the
sides at the same time allows you to remove
the battery pack 3.
Q Changing a collet
j Press the spindle lock 7 and keep it pressed.
j Rotate the clamping nut 5 until the lock
engages.
j Release the clamping nut 5 from the thread
and remove the collet 18.
j Insert the correct collet 18 and screw it tight
with the clamping nut 5.
j Release the spindle lock 7.
Q Inserting / changing tools
j Press the spindle lock 7 and keep it pressed.
j Rotate the clamping nut 5 until the lock
engages.
j Release the clamping nut 5 using the open
spanner end of the combination tool 23.
j If a tool is already inserted remove it.
j First insert the tool you wish to use though the
clamping nut
5
before you insert it into the
collet
18
.
j Press the spindle lock 7 and keep it pressed.
j
Insert the collet
18
into the threaded insert and
screw
the clamping nut 5 tightly on the thread
using the
open spanner end of the
combination tool
23
.
Note: Use the screwdriver end of the
combination tool 23 to release or tighten the
screw of the mandrels 12.
Q Switching on and off / Setting
the speed range
Switching on / Setting the speed range:
j Set the On / Off switch 1 to a position
between “2” and “10”.
Switching off:
j Set the On / Off switch 1 to position “0”.
Q Advice on working with
materials / Tools / Speed ranges
j Make sure that no debris from working the
material adheres to the tool. Use paraffin, cut-
ting oil or similar medium to lubricate the tool.
j Use the highest speed when working on steel
or iron with the milling bits.
j Use a short trial on a test piece to determine the
optimum rotational speed range for working on
zinc, zinc alloy, aluminium, copper and lead.
j Use the low speed range for working on plas-
tics and low-melting point materials.
j Use high speeds on wood.
j Use the medium speed range for cleaning,
polishing and buffing.
The following information shall be considered as
recommendatory only. Learn by practical experi-
ence which tools and settings are the best for the
materials you work with.
Operation