Assembling the liquidiser
Warning:
The blade is extremely sharp.
Handle it with great care. Risk of injury!
➩Place the blade 6 carefully on its retainer in the bowl 7.
➩Fill the bowl with the foodstuffs you wish to liquidise.
➩Place the lid 5 over the vessel and turn it until tight. Ensure that the lid lugs are guided into the grooves of the vessel on the edge.
➩Place the motor unit 3 on the lid 5, ensuring that it clicks in audibly.
Note:
The arrows on the motor unit and the accessory
must stand one above the other 
.
Operation
Warning:
Foodstuffs should not be too hot.
Fire Danger:
Never exceed the maximum operating duration of
1 minute for soft foodstuffs, respectively, 15 seconds for solid foodstuffs. Allow the appliance to cool down for 2 minutes before switching it on again.
When you have assembled the hand blender for
your particular purpose, place ...
➩the plug in the mains socket.
➩Hold down the switch 1 to process the foodstuffs at the standard speed.
➩Hold down the
➩When you have completed processing the foodstuffs, simply release the switch.
Wall mounting
Included are 2 plugs and 2 screws to enable the wall bracket w to be assembled. We recommend mounting the appliance close to a power point
➩Mark the position of drill holes using the appliance holder w.
➩Bore the holes with a 6 mm drill.
➩Insert the dowels into the drill holes.
➩Position the openings of the wall bracket over the bored holes, then fix it using both screws.
Cleaning
Danger of electrical shock!
Before you clean the hand blender, unplug the appliance from the power socket. Under no circum- stances may the motor unit 3 be cleaned by immer- sing it in water or holding it under running water.
Danger of injuries!
To prevent injuries, exercise caution when handling the extremely sharp blade 6. Reassemble the liqui- diser after use and cleaning to prevent injuries from exposed knife blades. Keep the blade out of the reach of children.
Attention!
The attachments of the hand blender may not
be cleaned in a dishwashing machine, this would damage them.
➩Unplug the power cord from the wall socket.
➩Clean the motor unit 3, the handblender 4, the lid 5 and the whisk holder 8 with a well squeezed out sponge.
➩Ensure that no water can enter the openings of 4 the hand mixer.
➩Clean the rest of the attachment components under running water and dry them off well with a
- 4 -
