Intended Usage
This Micro system is intended exclusively for the playback of audio CDs, MP3-CDs, CD-R, CD-RW, and for the playback of radio programmes. The Micro system is not intended for use in commercial or industrial environments. No warranty claims will be granted for damage resulting from improper use!
Items supplied
1Micro-system
2Loudspeakers
1Remote control (inc. 3 v battery, CR2025
1Operating instructions
Technical Data
Rated voltage: | 230 V~, 50 Hz |
Power consumption: | |
In standby | 3 Watt |
During operation | 15 Watt |
Frequency range radio: | MW (AM): 526.5 -1606.5 kHz |
| VHF (FM): 87.5 - 108 MHz |
Measurements (W x H x D) |
Main device: | 15 x 15,1 x 23,5 cm |
Per speaker: | 13 x 20,3 x 14,4 cm |
Weight | |
Main device: | approx. 1.7 kg |
Per speaker: | approx. 0.7 kg |
Speaker power rating.: | 2 x 2 Watt RMS |
Impedance: | 4 Ohm |
AUX - Input | 3,5 mm Jackplug |
Headphones output: | 3,5 mm Jackplug |
Maximum voltage at the | |
headphones output: | 300 mV |
CD Laser: | Laser class 1 |
Operating temperature: | 5° to 40°C |
Storage temperature : | —20° to 60°C |
Protection class: | II |
Remote control | |
Battery: | 1 x 3 V Type CR2025 |
Safety instructions
•Do not permit children to handle electrical devices without supervision, they cannot correctly assess the possible risks of injury.
•Unplug the power cord after every use and before cleaning, so as to prevent the device from switching on inadvertently.
•Check the device and all parts for visible damages. The safety concept can work only if the device is in a faultless condition.
•The power plug must always be easily accessible, so that in the event of an emergency the device can be quickly discon- nected from the mains power supply.
Risk of explosion!
•Do not throw batteries into a fire.
•Do not recharge the batteries.
•Never open batteries, never solder or weld batteries. The risk of explosions and injuries exists!
•Regularly check the condition of the batteries. Leaking batteries can cause damage to the remote control or to the device.
•If you do not intend to use the device for an extended period, remove the batteries.
Risk of electrical shocks.
•Connect the device to an electrical wall socket with a mains voltage of 230 V / 50 Hz.
•Do not operate the device if the connection cord or the power plug is damaged.
•The connection cord or device should be immediately re- paired or exchanged by the customer service department if they fail to function faultlessly.
•NEVER submerse the device in water. Wipe it only with a slightly damp cloth.
•Do not expose the device to rain and never use it in a humid or wet environment.
•Make sure that the power cord does not become wet during operation.
•You must not open the device housing or attempt to repair the device yourself. There is invisible radiation inside the device (Class 1 Laser) Furthermore should you do so, the safety concept of the device may be compromised and the warranty becomes void.
•Do not place objects containing fluids, e.g. flower vases, on or near the device.
•Notice regarding disconnection from mains-power
The Standby/On switch for this device does not disconnect
it from the mains-power source. Additionally, the device con- sumes power when in standby mode. To completely disconnect the device from mains power, the plug MUST be removed from the power socket. For this reason the device should be placed in a position where unhindered access to the power socket is assured at all times, so that in an emergency the plug can be quickly removed. To eliminate the risk of fire you should completely disconnect the plug from the wall socket if the device is not going to be used for an extended period, for example, during holidays.
•Always take hold of the power cable by the plug. Do not pull on the cable itself and never touch the power cable with wet hands, this could result in either a short circuit or you receiving an electric shock. Do not place the device, fur- niture or anything else on the power cable and ensure that it does not become clamped. NEVER tie knots in the power cable and do not bind it with other cables. Place the power cable in a position where it cannot be trod on. A damaged power cable can cause a fire or an electrical shock. Check the power cable from time to time. Should
it become damaged, contact your nearest authorized customer service centre or dealer to have it replaced.
Risk of fire!
•Do not use the device near hot surfaces.
•Do not place the device in locations that are subject to direct sunlight. If you do, it may overheat and become irreparably damaged.
•Never leave the device unattended while it is being used.
•Never cover the ventilation slots of the device while it is on.
Avoid placing this device in locations that provide insufficient ventilation or hot locations and do not place the device in direct sunlight or under strong artificial light sources.
