d) Cleaning with Steam
Warning: Always hold the device upright during use – never tip the device at an angle greater than about 45 degrees (in any direction). Hot water could drip out and cause burns.
➩Direct the accessory toward the surface to be cleaned. ...
• First at a distance of about 20 cm.
➩ Press the steam switch , steam now flows from the nozzle.
➩You can now move as close to the sur- face being cleaned as the material per- mits.
6.Cleaning the Device
Danger: Do not open any part of the housing. There are no operating elements inside. An open housing can create the risk of a
Before cleaning the device, ....
➩First unplug the power cord and ...
➩Let the device cool. This can take up to 30 minutes. approx.. Caution – the lid threads remain hot for some time, even after the rest of the device has already cooled.
➩Remove deposits from the boiler after about 10 - 15 uses. To do this, fill the boiler with clear water as described in 5.b). Then close the lid and shake the device forcefully.
➩Clean the outside surfaces and the power cord with a slightly damp wash cloth. Always dry the device well before using it again.
➩Do not use any cleansers, abrasives or solvents. These can damage the device.
7. Storage
➩Let the device cool completely before putting it away.
➩Empty the tank after you have finished working with the device. Bacteria may grow in the water remaining in the boiler – the bacteria may be blown into the air during the next use.
➩Store the device in a dry location.
➩Store the device in a place that is inaccessible to children and elderly persons. They may not properly appreciate the hazards involved with devices that generate heat.
8. Disposal
Care for the environment. If you wish to dispose of the device, dispose of it at a collection site for recycling of electronics.
9. Warranty & Service
The warranty conditions and the service
address can be found on the enclosed sheet.
Kompernaß GmbH
Burgstr. 21
www.kompernass.com
6
