Maintenance and Cleaning
AMaintenance and Cleaning
AMaintenance
aChanging the Dust Bag (TYPE KH 99)
You can see that the dust bag i is completely full when the filling level indicator q in the viewing window is 100 % RED.
• Turn the vacuum cleaner off and disconnect the power cord A from the mains.
• Press the release button { on the cover of the dust collection container and open the cover.
• Remove the full dust bag i from the dust bag holder u by pressing the clamping lever.
• Insert a new dust bag of TYPE KH 99 or type
Swirl ® Y 101 ® into the dust bag holder.
Note:
If no dust bag is inserted it is not possible to close the cover!
aChanging the Filter
•Switch the vacuum cleaner off and disconnect the power cord A from the mains.
•Press the release button { on the cover of the dust collection container and open the cover.
•Remove the full dust bag i from the dust bag container u by pressing the clamping lever.
Motor Protection Filter
The motor protection filter o protects the motor compartment against dirt (see illustration B).
•Remove the motor protection filter o from the holder.
10 GB/IE/CY
•Replace the filter insert by another one.
•Then reinsert the motor protection filter o in the holder.
Exhaust Air Filter
The exhaust air filter p collects fine dusts which would otherwise be given off to the surrounding air. The exhaust air filter should be changed after a visual check (see illustration F). If a replacement is needed, this can be purchased from our service addresses.
•Remove the exhaust air filter p from the holder.
•Replace the entire exhaust air filter by a new one.
•Insert the new exhaust air filter p into the holder and allow it to click into place.
aThread Catcher
Through the use of the thread catchers on the underside of the floor nozzle I, threads and fluff are vacuumed up particularly thoroughly. Worn thread catchers can be levered out with an appropriate tool. If a replacement is needed, this can be bought from our service addresses.
ACleaning
•Switch the vacuum cleaner off and discon- nect the power cord A from the mains.
•Please use a dry cloth for cleaning.
•The device should never be cleaned with moisture!
•Use a brush or tweezers to remove threads from the floor nozzle I, or vacuum these off from time to time with the crevice nozzle r.
