Kompernass KH 451 manual Emptying the pulp container and the filter, Cleaning and Care

Warning:

To avoid blockage of the juice outlet and/or damage to the appliance, regularly clean the juice outlet and juice container, and always after every usage.

Emptying the pulp container and the filter

You can extract juices continuously until the container for fruit pulp and vegetable mash s is completely full.

Warning:

Remove the plug from the power source when emptying the filter d.

When the extracted juices suddenly become thicker, or when you hear that the motor is running slower, the filter d must be emptied. When you have removed the fruit pulp/vegetable mash, reassemble the appliance.

Disassembly of the juice extractor

If you wish to disassemble the juice extractor, e.g. to clean it, proceed as follows:

1.Remove the power plug from the wall socket i.

2.Open the clasps r.

3.Remove the housing lid e with the stodger q.

4.Carefully lift up the juice container t. With this, the filter d releases itself from the drive shaft f.

You can now take the filter d out of the juice con- tainer t.

Cleaning and Care

Warning:

ALWAYS remove the power plug from the wall socket before removing or installing accessories and before cleaning the appliance. To avoid blockage of the juice outlet and/or damage to the appliance, all appliance and ancillary parts must be regularly, and after every use, cleaned free of fruit pulp and vegetable mash.

• Switch the appliance off at the On/Off switch

o.

•Soiling or overflowing fruit juices should be cleared away immediately, as fruit stains are difficult to remove later.

•For cleaning the appliance housing and the power cable, use a cloth that is only lightly moistened.

•Clean the stodger q, housing lid e and container for fruit pulp and vegetable mash s in warm soapy water and then carefully rinse them off.

The stodger q, housing lid e and container for fru- it pulp and vegetable mash s are suitable for clea- ning in a dishwasher and can be cleaned there. To clean the filter d, use the supplied nylon brush:

• Turn the lid of the stodger q until the arrow points

to the opened lock on the stodger shaft. You can now remove it. The nylon brush is inside the stodger q. To re-close the lid, place it on the stodger so that the arrow points to the opened

lock .

Then turn it until the arrow points at the closed lock . The lid now sits firmly.

•Hold the filter d (with the underside upwards) under running water and clean it with the nylon brush.

- 6 -