Kompernass PET 23 VARIO manual Careful handling and use of electrical power tools, Staples / nails

General safety advice for electrical power tools / Commissioning

4.Careful handling and use of electrical power tools

a)Do not overload the device. Always use an electrical power tool that is intended for the task you are under- taking. By using the right electrical power tool for the job you will work more safely and achieve a better result.

b)Do not use an electrical power tool if its switch is defective. An electrical power tool that can no longer be switched on and off is dangerous and must be repaired.

c)Pull the mains plug out of the socket before you make any adjustments to the device, change accessories or when the device is put away. This pre- caution is intended to prevent you from uninten- tionally starting the device.

d)When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not fa- miliar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people.

e)Look after the device carefully. Check that moving parts are working prop- erly and move freely. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Have dam- aged parts repaired before you use the device. Many accidents have their ori- gins in poorly maintained electrical power tools.

f)Keep cutting tools clean and sharp. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control.

g)Use the electrical power tool, acces- sories, inserted tools etc. in accord- ance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in

hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations.

Safety advice

for electric tackers

JEnsure that staples and nails cannot strike people or animals.

JProtect your eyes. Wear protective

glasses. This also applies to people who may be helping with the work

by supporting or holding the workpiece.

JMake sure the tool is switched off before you load the magazine 5 . To do this set the On /  off switch 8 to position “0”.

JDo not use the tool to fix electrical cabling in place.

JSecurely support the workpiece. Use clamps or a vice to grip the workpiece firmly. This is much safer than holding it in your hand.

JAlways work with the mains lead leading away from the rear of the device.

QCommissioning

The mains voltage at the mains socket must match that shown on the rating plate on the device. Devices marked with 230 V ~ can also be operated at 220 V ~.

QStaples / nails

Note: The device is designed to use the following standard, widely available staples and nails:

Type	mm
55	12, 14, 16, 18, 19
53	12, 14, 18
47	23

Note: Suitable accessories can also be obtained from the Service Centre for your country.

GB 9