Use
Switching on and off
Check the attached consumable or tool before use. It must be attached properly, not damaged, damp or cracked and must rotate freely. Test the opera- tion of the device for 30 seconds. If a disc is not round or vibrates, do not use it.
Look out for unusual noises or generation of sparks. Check that all the fastenings are correctly attached.
The device is fitted with an IPC electronic
Switching on:
jPress the ON/OFF switch 3 .
Switching off:
jRelease the ON/OFF switch 3 again.
Locking:
jPress the lock button 1 whilst pressing and holding down the ON/OFF switch 3 .
Releasing the lock:
jPress the ON/OFF switch 3 again.
mAttention: Wait until the electric motor has come to a complete standstill before you press the spindle lock button 10.
Setting the speed
jTo increase the speed, turn the rotation speed preselector wheel 11 towards the 6 (6 = high- est speed) setting.
jTo decrease the speed, turn the rotation speed preselector wheel 11 towards the 1 (1 = low- est speed) setting.
Changing a disc
JAlways wear protective gloves when changing cutting or roughing/grind- ing discs.
jPress the spindle lock button 10 only after the mounting spindle 8 has reached a standstill, Fig. B.
jPress the spindle lock button 10 to block the drive.
jRelease the clamping nut 7 using the spanner 12, Fig. C.
jPlace the roughing, grinding or cutting disc on to the mounting flange 9 with its labelled side facing towards the device.
jThen replace the clamping nut 7 , with its raised side facing upwards, on to the mounting spindle 8 .
jPress the spindle lock button 10 to block the drive.
jTighten the clamping nut 7 again with the spanner 12.
Note: Replace a new disc immediately if it runs unevenly or vibrates after being ex- changed.
jAfter replacing a disc let the device run under no load for 30 seconds as a safety check. Look out for unusual noises or generation of sparks.
jCheck that all the fastenings are correctly attached.
jPay attention to see that the arrow showing the direction of rotation on the cutting or roughing/ grinding discs (including diamond cutting discs) corresponds with the direction of rotation of the device (see arrow on the head of the device).
12
GB/IE/CY
