Handling and operation
Programming alarm wake times
The device has two alarms available. All settings for both alarms can be carried out independently from each other. You can select whether at the programmed time an alarm tone shall sound or the radio shall play.
NOTICE
►If, during alarm wake programming, no button is pressed for approx. 15 seconds the alarm will activate with the current settings.
Prerequisite: The device is in the operational mode clock/standby operation.
To set the wake time proceed as follows:
♦Press the Alarm1 button 8 or the Alarm2 button 9 . The set wake time
of the respective alarm is shown blinking in the display 3 and the indicator A1 and/or A2 appears. The weekday on which this alarm is to be activated is shown above the time indicator.
♦Set with the buttons Tune+ 13 and Tune– 12 the desired wake time. With each button press the wake time changes by one minute. Holding down the respective button for more than 2 seconds starts the speed setting.
♦Press the button AOT 5 to switch between the weekday combinations
♦Press and hold down the button AOT 5 for at least 2 seconds to switch between the weekday combinations and individual weekday setting alterna- tives.
NOTICE
►With the individual weekday setting alternative you switch between the days of the week with the button AOT 5 .
GB CY
Prerequisite: The device is in the operational mode clock/standby operation.
♦To select "Alarm tone" for the respective alarm press the Alarm1 button 8 or the Alarm2 button 9 several times in succession until, in the display 3 ,
the symbol 
appears.
SKRD 30 A1 | 17 |