Konftel 60W manual Adding your telephone and deleting other stored telephones

Using Bluetooth

2 sec

and

2 sec

Adding your telephone and deleting other stored telephones

Press and hold the trim button for 2 seconds until the blue LEDs start flashing.

Follow the instructions in your telephone handbook to add a new Bluetooth unit to your telephone.

Select Konftel 60W in the list of units detected.

Enter the password 0000.

If the pairing was successful, a short audible signal will be heard and the LEDs will stop flashing.

Removing all pairing information from Konftel 60W

Press and hold the – and + buttons at the same time for 2 seconds until you hear a short sound signal.

Adjusting the microphone sensitivity

The microphone volume can be adjusted during a call, but to avoid disturbing the call, it may be best to adjust it during a test call after the telephone has been paired. The volume can be adjusted in 5 steps. Please note that different telephones may have differ- ent volumes and the microphone volume on Konftel 60W may need to be adjusted if you connect a differ- ent make of telephone.

Press and hold the mute button for 2 seconds

	2 sec	until the LEDs start to flash and you hear a tone.
or		 Increase the microphone volume using the + but-
		ton and reduce it using –.

Adjust the microphone volume one step at a time until you can hear well at the other end. Please note that too high a volume may cause echoes and feedback.