Konica Minolta KD-200Z 75

Troubleshooting

●If inspecting the following items does not cure the problem, the dealer from whom you purchased the camera or a Konica Service Station (page 79).

		Symptom	Check			page

	Power	The power will not	• Batteries are depleted.			15
		turn on	• Batteries are not inserted with incorrect polarity.			16
			• AC adapter is not connected properly.			17

		The power will	• Batteries are depleted.			15
		suddenly turns off	• The camera is being used at low temperature.			77
		after turning it on	• New nickel-hydrogen battery is being used.			11

		Images cannot be	• Main switch is not set to	or	.	23, 36
		recorded even when	• Recordable SD Memory Card/Multi-Media Card is			63
		pressing the shutter	not inserted.
		button	• SD Memory Card is write-protected.			10
			• Maximum number of images has already been			28, 50
			recorded. ➝ Delete images that are no longer required.
			• The camera is set to self-timer.			34
			• Flash is being charged. ➝ Wait for a while.			22
	Recording
	Recording	The LCD monitor or	• The LCD monitor brightness adjustment is			35, 43
		The LCD monitor or	• The LCD monitor brightness adjustment is			35, 43
		image is not clear	not correct.
			• LCD monitor is dirty with fingerprints or dust.			74

		Focus cannot	• The subject is not in the center.			25
		be adjusted	• The subject is difficult to focus.			33
			• The front cover glass is dirty.			73
			• The recording mode and the distance between			22
			the camera and subject are not correct.

		Flash does not work	• The flash mode is set to “Flash Off”.			31

		Image colors are	• Image was taken under conditions where white			41
		not natural	balance could not be adjusted.

		Battery dies after	• AA alkaline batteries are being used.			17
		very little recording

8

Appendix

75

Contents

Digital Still Camera Page Contents Chapter 4 Basic Playback（/PLAY） /PLAY /PLAY） Advanced Operations（ /SET UP） Definitions of the symbols Warning Caution Page Page Page About the LCD monitor About the SD Memory Card/Multi-MediaCard Important Camera power supply Chapter 1 Preparation Accessories Optional accessories Preparation Main switch 5-waybutton MENU/DISPLAY button Status LCD CR-V3lithium battery (supplied) AA batteries (optional) AC adapter (optional) Inserting the card Removing the card q Pass the thin loop through the strap into the strap holder on the right side of the camera If the strap is difficult to pass through, use a toothpick, etc., to pull out the strap wPass the strap through the thin loop and pull w Set the main switch to Press the button to select the de sired language and press the SET button guage will appear tThe “Year” is selected Press the /button to adjust the year yPress the button to select “Month”. Press the /button to adjust the month uPress the button to select “Day” Press the /button to adjust the date Chapter 2 Basic Recording Holding the camera Viewfinder and LED Recording iSet the main switch to OFF The lens will automatically retract Focus Lock Recording Recording using the LCD monitor Notes and hints concerning recording Checking the recorded image (quick review) Number of recordable images Picture quality modes and number of recorded pixels The current setting can be checked on the icon display of the status LCD For details concerning each mode, see the respective pages (p.30) (p.31) (p.32) ● Press the MODE button and select than the preliminary flash, the mode is the same as Page Used when recording the subject at close distances When using macro recording, the use of a tripod is recommended e Press the MODE button and select rPress the DISPLAY button tWhile viewing the LCD monitor, press the (W) and (T) buttons to adjust the sub- ject size and image composition rLook through the viewfinder to adjust the im age composition, and press the (W) and (T) buttons to set the subject size Page Chapter 3 Advanced Recording rPress the /button to change the menu setting Press the SET button to exit the yRecord using the set conditions. (See “Re- cording” (page 23).) dingRecor Advanced qEnter the M-RECmenu mode and press the /button to select “Movie mode” w Press the / button to select the menu content The digital zoom can only be used when optical zoom is set to TELE (3⋅) /button to select “Digital Zoom” w Press the button to select “On” ePress the SET button to exit the M-RECmenu mode r Press the /button to select “Camera Exposure” button to adjust the expo sure compensation /button to select “White Balance” / button to change the set ting time the / button is pressed /button to select “AE mode” w Press the button and select “Regu lar” or “Spot” /button to select “Slow Shutter” Advanced dingRecor Page Default settings are: Chapter 4 Basic Playback About the Playback Screen Displaying images at 2⋅ magnification qSelect the image to display wPress the SET button The center of the image will be displayed at magnification of 2⋅ button to scroll the Chapter 5 Advanced Playback/Erasing Erasing one frame Erasing all frames qEnter the PLAY menu mode and press the /button to select “Index” w Press the button Images of 9 frames will appear at one time e Press the / / and buttons to se Page Applying the protect setting Removing the protect setting The file no. can be displayed on the image being played back. (See page 47.) /button to select “Image number” e100-0025 /button to select the “Screen Con trast” Selecting images (single frame/all frames) For “Select” For “ALL” Checking/determining images Deleting images from the list (single frame/all frames) For single frame For all frames Chapter 6 Advanced Operations Formatting the SD Memory Card/Multi-MediaCard Setting the Self Timer Setting the auto shut-offtime Resetting the file number Turning off the beep sound Setting the quick review Setting the date Setting the language Chapter Installing the Software and Transferring Images to a PC Installing the included software (CD-ROM)and KD-200ZUser’s Guide PC a to Images Transferring and eSoftwar the Installing Viewing the KD-200ZUser’s Guide Installing the USB device driver Transferring images Installing the Adobe Acrobat Reader Installing the KD-200ZUser’s Guide Notes Appendix Using the AC adapter (optional: DR-AC2) Cleaning the camera After using the camera About the SD Memory Card/Multi-MediaCard About image data About the LCD monitor Page Error message Page Warranty (separately attached) During the warranty period Outside the warranty period When requesting service FCC Statement: Declaration of Conformity Responsible party: KONICA PHOTO IMAGING Address: 725 Darlington Avenue Mahwah, NJ 07430, U.S.A Telephone number: (201)