48
HINT: In the ESS display, a corresponding number of LEDs 1–8 will light green to
indicate the last step you specify here.
NOTE: If you selected a “1 shot” mode (“*-#1”), the parameter will return to the
value specified by the setting of the effect when the steps have been completed.
HINT: When setting the STEP, you can use the √√
√√/®®
®® buttons to move through
steps 1–8, and the ▲/▼ buttons to edit the value at each step.
SPECIFYING THE TARGET PARAMETER CONTROLLED BY ESS
Specify the target parameter controlled by ESS in the same way that you specify
the target parameter controlled by the expression pedal.
HINT: For details, refer to “Expression pedal settings” on p.40.
If a target parameter is already assigned to the expression pedal, that target
parameter will be controlled (by the sequencer).
EXAMPLE ESS SETTINGS
In this example, we’ll assume that you’ve made expression pedal settings to
assign the PITCH parameter of the PITCH SHIFTER as the target parameter.
Before you continue, assign the PITCH parameter of the PITCH SHIFTER as the
target parameter for the expression pedal (see p.40).
1. Press the EXP STEP SEQ button to activate ESS.
2. Set value knob 1 SPEED to PEdL; this will stop the sequencer.
3. Use value knob 3 to specify how the sequencer will operate. For this example,
choose “8-A.” so that the sequencer will cycle through steps 1–8 and then 8–1.
4. Specify the value for each step. First use value knob 4 to set STEP to 1, and
then use value knob 5 to specify a VALUE of 0.
5. Repeat the above action for each step 2 through 8, and set these steps to val-
ues of 2, 4, 5, 7, 9, 11, and 12 respectively.
6. When you’ve finished making settings, try turning value knob 4. Relative to the
pitch of your bass sound, the pitch will change in a sequence of C, D, E, F, G,
A, B, and C.
7. Use value knob 1 to adjust the SPEED; the sequencer will run. The eight ESS
display LEDs located at the left of the pedal will light red in synchronization
with the sequencer.
4-A.1 (4 step alternate 2,
1-shot)
Advance from step 1 to step 4, then back to step 1
and stop. (12344321)
[4], [5] “STEP
”
1–8 Use value knob 4 to specify the step that you want
to edit, and use value knob 5 to specify the value
at that step.