Korg ER-1mkII Protect settings (Memory Protect), Saving the settings you modify in Global mode (WRITE)

6.Global mode

Synchronizing an external MIDI

device to the ER-1mk

as master

(int)

1. Use a MIDI cable to connect the MIDI OUT connector of the

ER-1mk

to the MIDI IN connector of the external MIDI de-

vice (sequencer or synthesizer etc.).

2. Use the cursor keys to make the parameter select LEDs indi-

cate CLOCK.

3. Rotate the dial to select "Int" (internal clock).

4. Make settings on the external MIDI device (slave) so that it

will receive MIDI Clock messages.

5. When you start playback on the ER-1mk

, the external MIDI

device will begin playback in synchronization.

When you perform the Reset & Play operation to begin

playback from the beginning of the pattern, the ER-1mk

will transmit only a MIDI Start message.

Protect settings(Memory Protect)

PROTECT on, oFF

This is the memory protect setting for Pattern mode and Song

mode. When protect is "on," the Write key will not function,

and it will not be possible to rewrite data or to receive MIDI

data dumps.

If you wish to save data you edited or to receive a data dump,

you must turn protect "oFF."

1. Press the Stop/Cancel key to stop playback.

2. Use the cursor keys to make the parameter select LEDs indi-

cate PROTECT.

3. Rotate the dial to turn Protect "on" or "oFF."

If you wish to save the Protect setting, perform the Global mode

Write operation.

This setting applies to Pattern mode and Song mode. In

Global mode and MIDI mode, it is always possible to Write

data regardless of the Protect setting.

With the factory settings, this will be "on."

Saving the settings youmodify in Global mode(WRITE)

When you perform the Write operation in either Global

mode or MIDI mode, the modified settings of both modes

will be saved.

Here's how to save the Global mode settings. If you wish to

save the settings you modify, you must perform this Write op-

eration. Each time you turn on the power, those settings will be

in effect. Conversely, if you do not wish to save the modified

settings, simply turn off the power without performing the Write

operation.

1. Press the Stop/Cancel key to stop playback.

2. Press the Global mode (or MIDI mode) key.

3. Press the WRITE key once (the key will blink). The display

will indicate "---."

4. Press the WRITE key once again to write the data.

To cancel, press the Stop/Cancel key.

In Global mode or MIDI mode, it is always possible to execute

the Write operation, regardless of the Protect settings (see the

previous section).

Never turn off the power while data is being written to

memory. This may damage the data.