Kramer Electronics TP-45 user manual TP-46 not shown in Figure

Connecting a Component/XGA – Audio Distribution System

TP-46(not shown in Figure 7).

The signal from the component video source is transmitted via the twisted pair cable; decoded and converted to component video and outputted on the Y, CB/PB, CR/PR OUTPUTS RCA connectors to the component video acceptor.

8.Connect the LINE OUT RJ-45 connector on the TP-46to a second TP-46unit1 (optional).

9.Similarly, you can connect the LINE OUT RJ-45 connector on the TP-46to additional TP-46units.

10.On the TP-46underside:

•If required, adjust2 the video output signal level and/or cable compensation equalization level3

•If necessary, set the HS and VS switches4, on the underside

1 Connect the required outputs to the second TP-46

2 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level

3 If more than one TP-46 unit is connected, adjust the level and cable compensation in sequence from the first TP-46 unit (that is connected directly to the TP-45) to the next and so on

4 By default, both switches are set down (for normal V SYNC and H SYNC polarity)

14 KRAMER: SIMPLE CREATIVE TECHNOLOGY