3.Connect the VIDEO OUT 1 to 20 BNC connectors to up to 20 acceptors (for
example, composite video recorders).
You are not required to connect all the acceptors.
4.Connect the AUDIO OUT 1 and 20 RCA connectors to up to 20 acceptors
(for example, the audio input on the video recorders).
You are not required to connect all the acceptors.
5.If needed, connect the VIDEO LOOP BNC connector to an acceptor (for example, a composite video display or another
6.Connect the power cord to the unit (not shown in the illustration) and then to
the mains electricity. Switch on the power.
Use the power cord supplied with the unit.
7.If needed, adjust the VIDEO GAIN or EQ controls or the AUDIO GAIN on the front panel.
8.Set the mode of operation by pressing one of the operating mode control switches (one set for audio and one set for video) as follows:
Press the 1:20 switch to split input “1” to all 20 outputs
Press the 2x1:10 switch to split input "1" to outputs
Press the 4x1:5 switch to split four inputs to four consecutive sets of five outputs each
Press the 1:10+2x1:5 switch to split input "1" to outputs
13 |