Connecting Your VP-350 13 High Resolution Uxga DA

Connecting Your VP-350 1:3 High Resolution UXGA DA

5Connecting Your VP-350 1:3 High Resolution UXGA DA

To output a UXGA1 signal from a computer graphics card to three monitors, as the example in Figure 4 illustrates, do the following:

1.Connect a UXGA1 source (for example, a computer graphics source) to the INPUT HD15F connector.

2.Connect the OUTPUT HD15F connectors to up to 3 acceptors, as follows:

Connect the OUTPUT 1 connector to an acceptor (for example, Display 1)

Connect the OUTPUT 2 connector to an acceptor (for example, Display 2)

Connect the OUTPUT 3 connector to an acceptor (for example, Display 3)

3.On the underside of the VP-350:

Set both the Hs and Vs switches to Hi-Z (TTL)

Slide the ID Bit switch to the left to set to ON

Set the RED, BLUE and GREEN COUPLING switches either to DC or AC, according to the output requirements

4.Connect the 12V DC power adapter to the power socket and connect the adapter to the mains electricity.

1 Or any resolution, such as VGA, SVGA, XGA, and so on