Amplifiers dissipate much of the power they consume in heat. The
ventilation. If you have to install the units on shelves or in a
cabinet, extra ventilation might be necessary. This can be easily done with fans in a variety of ways. Generally, with the front and rear open, 2 - 3 inches clearance each side and 8 inches above the amplifier, ventilation will be adequate.
The dimensions of the
INPUT CONNECTIONS
The
input uses the
the RCA connector. The pin assignment for the XLR's is: pin 1 = signal ground; pin 2 =
input. Only one of these inputs should be connected to a preamplifier.
The input that is not connected to the preamplifier can be used as an
output to a second amplifier for
INSTALLATION
After inspection of the amplifiers for any shipping damage they are
ready for instaila~ion. The wiring to and from the amplifiers, and all components in general, should be arranged in a neat, organized manner. Specifically, AC wires should be separated from audio wires. This avoids hum or other unwanted noise from being induced into the system.
The | has | four | sets | of | binding | post speaker |
connectors. | These | are wired | in | parallel and | have identical function. |
It is always preferable to run long interconnect cables to the amplifiers and keep speaker cable length to a minimum. Speaker cable does add impedance between the amplifiers, regardless of its guage. All KRELL amplifiers will drive the lowest impedances with ease. When
impedance is added in any significant amount, amplifier power is literally wasted in driving the cable, thereby reducing the maximum power that can be delivered to the speaker.
The feet on the