Krups 466 manual Preparing coffee, Inserting the Duo Filter, Filling the water chamber

•To replace the lid, put the front in place first and then snap the back down into place.

•Always place the glass carafe securely in place with the handle facing out and centered.

Inserting the “Duo Filter”

•Remove the DuoFilter (b) from its plastic bag. Rinse in tap water.

•Open the hinged lid of the coffee maker and remove the DuoFilter holder (a) (see fi- gure 1).

•Pivot the lower part of the holder and insert the DuoFilter into its housing (see figure 2).

•Replace the holder in the coffee maker and your machine is now ready for use (see figure 3).

Preparing coffee

Filling the water chamber

•Open the hinged lid. Using the glass carafe, pour in the desired quantity of cold water. (See figure 4). The water level indicator shows how much water you are filling into the container.

•The amount of freshly brewed coffee delivered after the brewing process will always be slightly less than the amount put into the water container. This is due to the minimum absorption of the water by the ground coffee. Therefore, it is recommended that you add a little extra water at the beginning so that you will have the number of cups you desire.

•Replace the glass carafe on the warming plate with the lid in position. (See fi- gure 5).

Putting in the ground coffee

•With the hinged lid opened, insert a size 4 paper filter (KRUPS #983) or Gold Tone Filter (KRUPS #026) into the the filter holder. You can purchase KRUPS size 4 paper filters (#983) or KRUPS Crystal Arome Gold Tone Filter (#026) at your local KRUPS retailer or by calling the KRUPS Consumer Service Department at 1-800-526-5377, 24 hours a day, 7 days a week.

•We suggest using one level KRUPS measuring scoop of ground cofee for each cup of robust coffee. After using your KRUPS coffee maker several times, you can adjust the measure to suit your own taste.

•Close the hinged lid, making sure that the filter holder is securely in place.

•Turn the machine on (g). An indicator light will illuminate.

“Stop ‘n Serve” feature

The “Stop’ n Serve” feature is KRUPS answer to the impatient coffee drinker’s clamor for “a quick cup of coffee!” This device automatically stops the flow of brewed coffee through the filter cone if the glass carafe is removed from the warming plate during the brewing cycle. You have about 20 seconds between the removal of the carafe and its being reinserted to pour one or two cups of coffee. The “Stop’n Serve” device closes off the filter cone so effectively that there is virtually no coffee-drip onto the waming plate. Once the carafe is replaced, the brewing cycle and the flow of coffee into the carafe are resumed.

If coffee does drip onto the warming plate after removal of the carafe, it is usually an indication that too much ground coffee has been placed into the paper filter. This causes the water that jets into the filter cone to overflow between the paper filter and the sides of the filter cone. The overflow carries coffee grounds that interfere with the snapshut action of the filter holder, thus allowing brewed coffee to continue to drip through.

If this blockage and subsequent dripping do occur, replace the glass carafe immediately and allow the full brewing cycle to brewing cycle to run its course, Do not remove the filter until the brewing cycle is completed.

Preparing “wake-Up” coffee (model #467)

This feature enables you to enjoy freshly brewed coffee at any pre-selected time within a 24-hour period.

•First set the digital clock (see “Setting the time”)

9