KTI Networks KGC-311 Applying Power, Installing SFP Fiber Transceiver, Typical Applications

Applying Power

Before you begin the installation, check the AC voltage of your area. The AC power adapter which is used to supply the DC power for the device should have the AC voltage matching the commercial power voltage in your area. The DC power input of the converter is: DC IN 0.24A min. @ 7.5V

Installing SFP Fiber Transceiver

To install an fiber transceiver into an SFP slot, the steps are:

1.Turn off the power to the device unit.

2.Insert the SFP fiber transceiver into the slot. Normally, a bail is provided for every SFP transceiver. Hold the bail and make insertion.

3.Until the SFP transceiver is seated securely in the slot, place the bail in lock position.

Note that SFP-A is reserved for MM transceiver and SFP-B is reserved for Single mode transceiver.

Typical Applications

Gigabit Ethernet 1000Mbps MMF to 1000Mbps SMF

Fast Ethernet 100Mbps MMF to 100Mbps SMF

5

7

DIN-Rail Mounting

For a Din-Rail chassis, the media converter can support mount- ing on a Din-Rail. An optional Din-Rail bracket, KC-3DR can be purchased separately. Consult your dealer for details. The following figures show an example after bracket installation:

Center Chassis Installation

The media converter can also be installed in KC-1300 center chassis. The center chassis provides the power supply to the converter also with optional power redundancy. Up to 16 units can be installed in one chassis. Unscrew and remove the cover of the center connector before inserting the converter into the chassis. Refer to the operation manual of center chassis KC- 1300 for more information.

6

8

FCC NOTICE

This device complies with Part 15 Class B the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This de- vice must accept any interference received, including the in- terference that may cause undesired operation.

CE NOTICE

Marking by the symbol indicates compliance of this equip-

ment to the EMC directive of the European Community. Such marking is indicative that this equipment meets or exceeds the following technical standards:

EMC Class B
EN61000-6-3	IEC61000-6-1
EN55022	CISPR22
EN61000-3-2	IEC61000-3-2
EN61000-3-3	IEC61000-3-3
EN61000-6-1	IEC61000-6-1
EN55024	CISPR24
EN61000-4-2	IEC 61000-4-2
EN61000-4-3	IEC 61000-4-3
EN61000-4-4	IEC 61000-4-4
EN61000-4-5	IEC 61000-4-5
EN61000-4-6	IEC 61000-4-6
EN61000-4-8	IEC 61000-4-8
EN61000-4-11	IEC 61000-4-11

The information contained in this document is subject to change without prior notice. Copyright (C) All Rights Reserved.

Trademarks

Ethernet is a registered trademark of Xerox Corp.