8 |
|
|
|
Problem | Possible cause |
The appliance is noisy | The appliance is not supported |
| properly |
|
|
The appliance does not | The appliance is switched off. |
operate. The lamp does |
|
not operate. |
|
| The mains plug is not connected |
| to the mains socket correctly. |
| The appliance has no power. |
| There is no voltage in the mains |
| socket. |
The lamp does not work. | The lamp is in |
| The lamp is defective. |
The Pilot light flashes. | The appliance is not working |
| properly. |
The compressor operates | The temperature is not set cor- |
continually. | rectly. |
| The door is not closed correctly. |
Solution
Check if the appliance stands sta- ble (all the four feet should be on the floor)
Switch on the appliance.
Connect the mains plug to the mains socket correctly.
Connect a different electrical appli- ance to the mains socket. Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Contact a qualified electrician.
Set a higher temperature.
Refer to "Closing the door".
The compressor does not start immediately after pressing the Supercool button, or after changing the temperature.
Water flows on the rear plate of the refrigerator.
The door has been opened too frequently.
The product temperature is too high.
The room temperature is too high.
The compressor starts after a pe- riod of time.
During the automatic defrosting process, frost defrosts on the rear plate.
Do not keep the door open longer than necessary.
Let the product temperature de- crease to room temperature before storage.
Decrease the room temperature.
This is correct.
This is correct.
Temperature cannot be set .
The temperature in the appliance is too low/high.
The temperature in the re- frigerator is too high.
Supercool function switched on.
The temperature regulator is not set correctly.
The door is not closed correctly.
The product temperature is too high.
Many products are stored at the same time.
There is no cold air circulation in the appliance.
Switch off Supercool manually, or wait to set the temperature until the function has reset automatically.
Refer to "Supercool function".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de- crease to room temperature before storage.
Store less products at the same time.
Make sure that there is cold air cir- culation in the appliance.
Replacing the lamp | 1. Disconnect the mains plug from the |
| mains socket. |
