Kustom Dart 10 owner manual

1.) Guitar Input Jack - This is a 1/4” 2-conductor input jack for plugging in your instrument. It is intended for guitars but will accept other instruments as well.

2.) Overdrive Switch - This switch turns the overdrive circuit on or off. When engaged, the gain control then determines the amount of distortion added to the sound.

3.) Gain - Adjust this control clockwise to increase the amount of distortion. Use in the lower ranges (counter clockwise) to produce less distorted tones. As you increase the gain (clockwise), the amount of distortion can range from “Classic Rock” to heavy, modern rock.

4.) Voice - This is an overall tone control. In the extreme counter-clockwise position, it is specifically designed to give a full bodied sound with lots of midrange tones. By increasing this control, you proceed to boost the bass and treble regions, but reduce the midrange content of the sound.

5.) Volume - This is the output volume control for the entire amplifier. It follows the tone circuit.

6.) Headphone Jack - This is a 1/4” 3-conductor jack for plugging in headphones. It will sum the signal and put the sound in both ears, thereby creating a pseudo-stereo sound. Volume will be determined by the volume control. It will disconnect the internal speaker when plugged in. This will allow quiet practicing.

7.) Power Indicator - When lit, the amplifier is turned on and ready for use.

5