HV™ 30
Specifications
Tubes | Preamp |
| |
Output Power | 30 Watts, RMS |
| 8 Ohms @ 5% THD |
Speakers | 1 X 12 Inch |
| Celestion G12P80 |
Input Impedance | Single Input |
| 100 K ohms |
Hum & Noise |
| Residual Noise, all level controls 0% (minimum) | |
Nominal Signal to Noise |
| Rhythm Channel, with Volume half and Master Maximum, Boost on 10 | |
|
|
|
|
System Gain | 30 dBV |
| Rhythm Channel Nominal gain, Volume @ 5 |
All measurements taken with 1 KHz | 60 dBV |
| Rhythm Channel Maximum gain, Volume @ 10 |
30 dBV |
| Lead Channel Nominal gain, Volume @ 5 | |
input signal, Tone controls flat, |
| ||
60 dBV |
| Lead Channel Maximum gain, Volume @ 10 | |
Effects off. Measured at speaker with |
| ||
6 dBV |
| Gain increase at 1 kHz when Crunch/Grind is pressed | |
8 ohm load. |
| ||
6 dBV |
| Gain increase at 1 kHz when Fat/Lean is pressed | |
|
| ||
|
|
|
|
XLR Direct Output |
| After power amp with speaker emulation | |
Digital Effects | 24 bit DSP module, 16 effects w/programmable | ||
|
|
| |
Footswitch Jack | Tip Selects Rhythm/Lead, Ring selects Effects On/Off | ||
Recommended footswitch | |||
|
|
|
|
| USA/Canada |
| 120VAC/60Hz, 60W nominal |
| Europe |
| 230VAC/50Hz, 60W nominal |
Power Requirements | UK |
| 230VAC/50Hz, 60W nominal |
| Australia |
| 240VAC/50Hz, 60W nominal |
| Japan |
| |
|
|
|
|
Dimensions/Weight | mm/kg |
| 425 (Height) x 459 (Width) x 246 (Depth), 15.4 kg |
Inches/Pounds |
| 16 3/4 (Height) x 18 (Width) x 9 5/8 (Depth), 34 lbs | |
|
|
9