KBA30
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 |
1.) CD/Tape Input - this 1/4” 3 conductor jack will allow you to plug in a CD player, tape or any other source to practice along with. It sums the left and right signals into a mono signal and passes it through to the amplifier section. To control the volume of the source, adjust the output volume of the device. We suggest you turn the volume all the way down then plug in and adjust the volume according to your taste.
2.) Guitar Input - this is a 1/4” 2 conductor input jack for plugging in your instrument. It is intended for bass guitar or
3.) Volume Level - this control is the output volume control for the bass guitar input. Slowly increase the control to increase the volume. If you are using a bass guitar with an
4.) Notch - this control is a dramatic cut filter. It is “notched” at a rate of
5.) Low - this control is the bass control. It is active and set to boost or cut frequencies at 60 Hz. This will effect the low frequency signals. Turning it fully clockwise, the signal is boosted 15 db. Turning it counterclockwise, the low will be rolled off
6.) Lo Mid - this control is the Low Midrange control. It is active and set to boost or cut frequencies at 250 Hz. This will effect the
7.) Hi Mid - this control is the High Midrange control. It is active and set to boost or cut frequencies at 1.5KHz. This will effect the
8.) High - this is the high frequency control. It is active and set to boost or cut frequencies at 8KHz. This will effect the high frequency signals. Turning it fully clockwise, the signal is boosted 15 db. Turning it counterclockwise, the highs will be rolled off
9.) Headphone Jack - this is a 1/4” 3 conductor jack for plugging headphones. It will sum the signal and put the sound in both ears, thereby creating a
10.) Jewel Light - this jewel light lets you know that the amplifier is on.
11.) Power - this switch turns on and off the AC power to the amp.
Back Panel - (not pictured)
Speaker Out - this is a 2 conductor 1/4” speaker output jack. This will disconnect the internal speaker and allow an external speaker cabinet to be employed. Rating is 8 ohms.
Line Output - this is a 2 conductor 1/4” line output jack. This will allow an external amplifier or mixing board to be supplied with the signal from this amp. This is output is attenuated and comes from the power amp signal.
Effects Loop - these are 2- 2 conductor 1/4” jacks. This will allow an external effects device or equalizer to be patched back in before the power amp section in this amp. One is send and the other is return.