About the Master Section
The master section gives you final control over the sum of what is happening in the input section. In other words, the adjustments you make in this section will affect all channels evenly.
Sub Volume Control (1)
When using a powered subwoofer that is connected into the sub output jack (U), this control becomes a volume control for the subwoofer. The output signal level can be adjusted by + or - 12dB.
When not using a powered subwoofer, this control becomes part of the equalizer section. This control will adjust the sub frequencies by + or - 12dB.
Equalizer Controls (2)
These controls are used to adjust the sound to your taste. The individual frequencies (100Hz, 250Hz, 500Hz, 1KHz, 2KHz, 4KHz, 10KHz) can be adjusted by + or - 12dB.
Master Volume (3)
This control is used to adjust the overall output volume of the mixer. Adjusting this control will also adjust the output of the sub output jack (U) when a powered subwoofer is used. Although the sub volume control (1) will still adjust the output level up or down.
Power Indicator (4)
This indicator will light when power is applied to the amplifier.
Monitor Volume (5)
This control will adjust the overall output volume going to the monitor output jack (T).
Effects Volume (6)
This control will adjust the overall amount of effects that will be mixed into the outputs.
Effects Selector Switch (7)
This switch is used to select the type of digital effect you want to use. There are 16 different digital effects to choose from. These are the available effects:
Reverb: | Delay: |
Small Room | Doubler |
Medium Room with Pre Delay | Slapback |
Large Room | Echo |
Large Hall | Delay 400ms |
Plate Reverb | Double TakeTM |
Chorus: | Combos: |
Chorus Slow | Double Take/Reverb |
Chorus Fast | Chorus/Reverb |
Double Take/Chorus | Chorus/Delay/Reverb |
Effects To Record Out Switch (8)
This push button switch is used to send effects to the record out jacks (V) on the back of the mixer.
Effects To Monitor Switch (9)
This push button switch is used to send effects to the monitor out jack (T) on the back of the mixer.
Effects Active (0)
This push button switch is used to activate the digital effects. When this switch is set to the “off” position the effects will be bypassed.
10
