Kwik Tek 800-553-5953 manual Maintenance

SGF SEAT GRINDER

MAINTENANCE

Your Kwik-Way SGF Seat Grinder is designed to require minimal maintenance. However, some basic maintenance assures the unit will continue to operate in a satisfactory manner.

1.The motor features permanently sealed bearings that require no routine oiling.

2.The gears located in the nose housing may require lubrication on a yearly basis. (depending on use) We recommend the following:

a.Remove the four cap screws and two pan head screws holding the nose to the motor housing.

b.Keep the motor armature in place by holding against the fan with a screwdriver (prevents armature from slipping out of the brushes) and remove the nose housing.

c.Once removed, add approximately one teaspoon of grease to the gear cavity of the housing.

CAUTION: Do not overfill, excess grease will cause the gears to run hot.

3.Brushes should be removed and inspected for wear every 3 months or sooner depending on use, replace them as required.

KW Products Inc. 800-553-5953 11.

500 57th Street, Marion, IA 52302 USA

Copyright 2004 All Rights Reserved

Equipment specifications, options and accessories subject to change without