15
English
Adjusting the print position
When using duplex printing, the image on the reverse side of the paper may be
slightly out of alignment with that on the front side. If this occurs, the image
position can be adjusted either to the left or right by about 2 mm. When using the
duplex unit, the reverse side of the paper (the second page) is printed first,
followed by the front side (the first page). Adjustment of the print position affects
only the image printed on the front side of the paper; i.e., print positioning on
odd-numbered pages.
Adjustment procedure
1. Prepare a double-sided print sample using the duplex printing mode.
2. Pull the duplex drawer out as far as it will go.
3. Open the two covers inside the drawer, then loosen the thumbscrew
located on the right inside of the drawer. This frees the adjuster, allowing
you to move it to the right or left. The adjuster is set to the center
position upon shipment from the factory.
The scale located to the right of the thumbscrew is calibrated in
millimeters. Moving the adjuster to the right of the center position moves
the print position a corresponding amount to the left. Conversely, moving
the adjuster to the left moves the print position a corresponding amount
to the right.
Covers
Adjuster
Scale
Thumb screw
Duplex drawer