Garden Thermometer with Solar Lighting

Model 306-645

FEATURES

Clear Functional Design

Large digital Display with 2 Diff Modes

Maximum and Minimum

Clock

Automatic Backlight

Solar Panel with 180 Degree Rotation

Weather Resistant

1

BUTTONS (see Fig. 2)

I.MODE Button

J.+ 1 Button

K.Display Mode Switch

L.+/- 1hr Button

M.Battery Compartment

N.Temperature Probe

Fig. 2

DISPLAY (see Fig. 1)

A.Battery Indicator

B.Time/Temperature

C.DST (Daylight Saving Time) Indicator

D.Auto Reset

E.Display Mode

F.PM Indicator

G.MAX Temperature

H.MIN Temperature

O.Solar Panel

Fig. 1

2

SETUP INSTRUCTIONS

Pull off the protection foil on the display.

Open the battery compartment with a small Phillips screwdriver.

Insert the AA NiMh rechargeable battery into the top position. Make sure to observe the correct polarity.

Insert the AA alkaline battery into the bottom position. Make sure to observe the correct polarity.

Note: The upper battery is the illumination battery. The lower battery provides power for all other functions.

Note: The 1.2V NiMh rechargeable battery for the backlight is not fully charged when shipped. For maximum efficiency it is recommended to charge the battery fully (place battery into display and display unit outside on a sunny day) before first use. Alternatively, the rechargeable battery can be charged with a NiMh battery charger.

Replace the battery compartment cover.

All LCD segments will light up for a few seconds.

The thermometer is now ready to use.

On the display, 0:00 is flashing and the DST symbol (see Fig. 1, C) is flashing.

If you are setting up the thermometer during Daylight Saving Time, press the +/-1hrbutton for confirmation while the DST symbol is flashing and the DST symbol will remain, indicating that the unit is in DST mode.

If there is no confirmation within 15 seconds, the DST symbol will stop flashing and will disappear. If this has happened and you need to put your thermometer into DST mode, see the section on Daylight Saving Time later in this manual.

SET THE CLOCK

Slide the switch to position B or C.

When the time appears in the display, press and hold the MODE button to enter the setting mode.

The hour digits in the upper display start flashing.

Press the +1 button to adjust the hour value.

3

4

Page 1
Image 1
La Crosse Technology 306-645 manual Features, Setup Instructions, SET the Clock