La Crosse Technology Wireless Temperature Station specifications Function Keys, Battery Change

successful the reception is tried for 40 seconds on 910MHz. This will also be done for re- synchronization.

IMPORTANT:

Transmission problems will arise if the setting for additional transmitters is not followed as described above. Should transmission problems occur, it is necessary to remove the batteries from all units and start again the set-up from step 1.

HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER The Temperature transmitter uses 2 x AA, IEC LR6, 1.5V batteries. When batteries will need to be replaced, the low battery icon will appear on the LCD of the Temperature Station. To install and replace the batteries, please follow the steps below:

1.Remove the battery compartment cover.

2. Insert the batteries, observing the correct polarity (see marking).

3. Replace the battery holder to the unit.

Note:

In the event of changing batteries in any of the units, all units need to be

9

Please participate in the preservation of the environment. Return used batteries to an authorised depot.

FUNCTION KEYS:

Temperature Station:

The Temperature Station has only four easy to use function keys.

Set Key	Channel key
+ key	Min/max key

11

reset by following the setup procedures. This is because a random security code is assigned by the transmitter at start-up and this code must be received and stored by the Temperature Station in the first few minutes of power supplying.

HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION

The Temperature Station uses 2 x AAA, IEC LR3, 1.5V batteries. When batteries will need to be replaced, the low battery icon will appear on the LCD. To install and replace the batteries, please follow the steps below:

1. Lift up the battery compartment cover.

2. Insert batteries observing the correct polarity (see marking).

3. Replace compartment cover.

BATTERY CHANGE:

It is recommended to replace the batteries in all units every 12 months to ensure optimum accuracy of these units.

10

SET key (Setting)

•Press and hold for about 3 seconds to enter the Manual setting mode: 12/24 hour time display, and manual time settings

MIN/MAX key (Min/ Max temperature)

•Used to toggle between the minimum and maximum recorded readings of indoor & outdoor temperature.

•Press and hold to reset minimum and maximum record when min or max record is shown.

+ key (Plus)

•To make adjustments for manual settings.

CH key (Channel)

•To toggle between the Outdoor transmitters 1, 2 and 3 (if more than 1 transmitter is used)

12