La Crosse Technology WS-8001U II Wall Mounting, Maintenance & Care, Troubleshooting, Problem

folded out towards the edge. Once the Foldout table stands are extended, place the Moon Phase Clock in an appropriate location.

II)WALL MOUNTING

1)Using a straightedge, horizontally space at 3- 15/16 of an inch (100.58mm) three screw positions on a wall.

2)Install three mounting screws (not included) into a wall within transmission range—leaving approximately 3/16 of an inch (5mm) extended from the wall.

3)Place the Moon Phase Clock onto the screws, using the hanging holes on the backside. Gently pull the Moon Phase Clock down to lock the screws into place.

MAINTENANCE & CARE

•Extreme temperatures, vibrations, and shock should be avoided to prevent damage to the units.

•Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents—they may mark and damage the displays and casings.

•Do not submerge in water.

•Immediately remove all low powered batteries to avoid leakage and damage. Replace with new batteries only, and of recommended size.

•Opening the casings invalidates the warranty. Do not try to repair the units. Contact La Crosse Technology for Repairs.

TROUBLESHOOTING

Problem:	The LCD is faint.
Solution:	1)	Replace the batteries.
Problem:	“OFL” appears in the LCD.
Solution:	1)	Move unit to an area with warmer or cooler surrounding
	temperature. Current surrounding temperatures are outside
	measuring range.
Problem:	No reception of WWVB signal.
Solution:	1)	It may help reception to face the front of the Moon Phase
		Clock in the general direction of Ft. Collins, Colorado.
	2)	Wait overnight for signal.
	3)	Be sure the Moon Phase Clock is at least 6 feet from any
		electrical devices, i.e. TV sets, computers, or other radio
		controlled clocks.
	4)	Remove batteries for five minutes, reinsert and leave the unit
		alone overnight without pressing buttons.
	5)	If problems persist contact La Crosse Technology.

10