DETAILED SETUP GUIDE
I. BATTERY INSTALLATION (When one Temperature sensor is being used)
1.First, insert the batteries to the Temperature sensor (see “A. Temperature sensor” below).
2.Within 2 minutes of powering up the sensor, insert the batteries to the Weather Station (see “B. Wireless Weather station” below). Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature and the time as 12:00 will be displayed, and the signal reception icon will flash. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. Once the indoor data is displayed user may proceed to the next step.
3.After the batteries are inserted, the Weather Station will start receiving data signal from the sensor. The outdoor temperature should then be displayed on the Weather Station. If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1.
A. TEMPERATURE SENSOR
1.Remove the Battery Cover.
2.Observing the correct polarity, install 2 “AAA” Alkaline
3.Replace the Battery Cover.
Battery
Compartment
Remote
Temperature
Sensor
Battery Cover
B. WIRELESS WEATHER STATION
Note: After the batteries are installed, DO NOT press any buttons. This may interfere with the signals, causing temperatures to register incorrectly.
1.Remove the Battery Cover on the back of the Wireless Weather Station.
2.Observing the correct polarity, install 2 “AA” Alkaline Batteries.
3.Replace Battery Cover.
4.Wait 15 minutes before pressing any buttons.
Battery | Battery |
Compartment | Cover |
Wireless Weather
Station
Sensor signal reception icon*
5
