La Crosse Technology WT-8029U To Install / Replace Battery, Charged by solar panel

∙WWVB Radio controlled time with manual time setting

∙Time display: hour, minute, second

∙12/24h time format display

∙Alarm setting with snooze function

∙Calendar display

∙Weekday display (4 languages to choose from: English, Spanish, French, German)

∙Time zone setting

∙Daylight savings time ON/OFF option (DST)

∙Solar mode setting

∙Indoor temperature display in ºF/ ºC selectable

∙Indoor humidity display in RH%

∙Primary Alkaline battery or rechargeable Alkaline battery selection

∙Low battery indicator

∙Wall mount or freestanding

TO INSTALL / REPLACE BATTERY

The solar clock can use either the included 1 x alkaline rechargeable battery (charged by solar panel) or 1 x AA alkaline battery (non-rechargeable; not included).

INITIAL SETUP

It is very important to follow these steps:

1.First, remove the label covering over the battery compartment on the back.

2.Open the battery compartment, and MAKE SURE that the battery switch is in the BATTERY position (not the SOLAR position).

Battery switch in the BATTERY position

3.Now locate the battery insulator tab, and gently pull to remove it.

4.Slide the battery switch to the SOLAR position

5.Battery switch in the SOLAR position

6.Continue to section titled “Setup After Changing/Installing the Battery”

3

TO INSTALL / REPLACE BATTERY

The included alkaline rechargeable battery should provide you with many years of service. If your battery needs to be replaced, we suggest you use a fully charged AA Alkaline.

Rechargeable batteries should be fully charged before inserting into clock. Alkaline rechargeable batteries are recommended.

If you choose to use a non-rechargeable battery, the battery switch MUST be moved to the BATTERY position (not the SOLAR position). In this position, the solar cells do not charge the battery.

REGARDLESS OF THE TYPE OF BATTERY INSTALLED, THE BATTERY SWITCH MUST BE IN THE BATTERY POSITION WHEN THE BATTERY IS INSERTED.

If a rechargeable battery is used, the Battery switch should be moved to the SOLAR position AFTER it is has been inserted.

To use the included rechargeable Alkaline battery

(charged by solar panel):

1.It is important to allow sufficient light to reach the solar panel while activating the solar clock. Make sure the lights are on in the setup room and the solar panel is facing a 60W light bulb or brighter - do not cover with hands or other objects.

2.Replace battery cover

3.Remove the black protective foil on the solar panel.

DO NOT SET THE CLOCK.

To use a non-rechargeable Alkaline battery:

1.Remove the included rechargeable AA battery from the compartment.

2.Use the switch to select the alkaline battery (see below).

4