Land Pride DP25 PD15, PD25, & PD35 Assembly, Part No. 317-142A, Refer to on page, Refer to Figure

Land Pride

PD15, PD25, & PD35 Assembly

PD15, PD25, & PD35 Assembly

Part No. 317-142A

A detailed listing of parts for this accessory kit is provided on page 5. Use the list as a checklist to inventory parts received. Please contact your local Land Pride dealer for any missing hardware.

Refer to Figure 2 on page 1:

The optional storage stand may be used when the PD15, PD25, and PD35 Post Hole Digger is not in operation. It will help prolong digger’s life by keeping the unit off the ground where moisture and debris are more likely to collect causing undue damage to the digger. Also, the storage stand design aids in mounting and dismounting the Post Hole Digger to and from the tractor.

PD15, 25, & 35 Storage Stand Assembly

Refer to Figure 4:

The Storage Stand Assembly consists of an A-frame storage stand (#4), clamping knobs (#11), cradle (#5), and a bag of (4) - 3/8”-16 x 1” long GR5 bolts:

1.Unscrew locknuts (#8) and remove

1/2"-13 x 3 1/2" GR5 hex head bolts (#7). Slide auger (#13) off of gearbox output shaft.

2.Remove existing hex head cap screws (#6), lockwashers (#10) and flat washers (#9) from underside of gearbox. Remove auger guard (#1).

3.Position cradle (#5) between auger guard (#1) and gearbox (#12). Make sure cradle pins (#3) are positioned to the back as shown.

4.Use four new hex head bolts (#6), lock washers (#10) and flat washers (#9) in hardware bag to attach cradle (#5) and existing guard (#1) to gearbox (#12).

5.Reattach auger to gearbox output shaft with existing auger bolts (#7) and locknuts (#8).

PD15, 25, & 35 Storage Stand Operation

Refer to Figure 4:

Lower auger tip to the ground at the location you plan to disconnect the Post Hole Digger from the tractor. Set tractor park brakes, turn tractor engine off, and remove ignition key before dismounting tractor.

Always chock tractor wheels for an extra measure of safety if you stop on a gentle slope.

NOTE: Do not disconnect Post Hole Digger from a tractor on a steep slope. Injury to personnel and equipment may result.

Attach storage stand (#4) to cradle (#5).

1.Make certain guide slots (#2) at end of storage stand are securely positioned over cradle pins (#3). Secure storage stand to cradle with clamping knobs (#11).

2.Without starting the tractor, lower boom (#14) to rest yoke hitch pins securely in support angles on the storage stand. Some adjustment to the support angles may be required.

3.Disconnect 3-point hitch.

4.Start tractor and drive away being careful not to catch on the Post Hole Digger and Storage Stand.

20872

PD15, 25, and 35 Storage Stand Assembly

Figure 4

4 Post Hole■Digger Storage Stand Assembly Instructions Manual No. 317-189M 10/06/08