Land Pride | Table of Contents |
Section 1 Assembly and Setup
Section 1 Assembly and Setup
Tractor Requirements | Upper Hitch Arms |
This mower is designed with a
NOTE: In order to maintain steering control, ballast may need to be added to your tractor. To determine whether or not to add the ballast, refer to your trac- tors’ operator manual.
Refer to Figure 1-1:
1.Remove the upper hitch bars (#1), upper hitch braces (#2), and upper pivoting hitch subassembly (#3) from the storage position on top of the mower deck.
2.Bolt the upper hitch braces to the mounting tabs on back of the deck using 1/2" bolts (#4), lock washer (#5), and hex nut (#6).
3.Mount the upper hitch bars (#1), to the inside of front hitch plates on the mower frame using the 5/8" x 1 3/ 4" long bolts (#7), lock washers (#8) and hex nuts (#9).
4.Remove 5/8" x 5" long bolt (#10), lock washer (#8), and hex nut (#9) from the upper pivoting hitch subas- sembly.
5.Swing the upper hitch bars (#1) up to a vertical posi- tion. Raise the upper hitch braces (#2) up inside the upper hitch bars as shown.
6.Assemble upper pivoting hitch (#3), spacer top hitch (#11), 5/8" x 5" long bolt (#10), lock washer (#12), and hex nut (#13) as shown.
FDR1560 & FDR1572
15028
Upper Hitch Arms Assembly
Figure
5/8/08 | FDR15 Rear Discharge Grooming Mowers | 9 |