MATERIAL SAFETY DATA SHEET
Page 2 of 3 |
|
| |
|
|
| |
| Section 5: Fire Fighting Measures |
| |
Suitable extinguishing media: CO2, dry chemical, foam or water. | Unusual Fire or explosion hazards: Combustible |
| |
Fire Fighting Instructions: Generally by sprinkling or extinguisher. | powder. Dust of this product at sufficient concentrations |
| |
|
| can form explosive mixtures with air. |
|
Hazardous Combustion Products: CO2, Carbon Monoxide and smoke. |
| ||
Miscellaneous: This material is capable of creating a dust explosion. Keep away from heat, sparks and flame. |
| ||
UEL: n/a | LEL: n/a |
|
|
Section 6: Accidental Release Measures
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix
AAAToner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue with soap and cold water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.
| Section 7: Handling and Storage |
Special Handling: | Cleanse skin after contact before eating, drinking or smoking. |
| Do not handle in areas where the wind blows. Flying powder may enter eyes. |
Special Storage: | Minimize the breathing of dust. |
Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Below 35C (95F) | |
|
|
| Section 8: Exposure Control and Personal Protection Information: |
Respiratory Protection: none required under normal use.
Eye Protection: none required under normal use.
Hand Protection: none required under normal use.
Skin Protection: none required under normal use.
Section 9: Physical and Chemical Properties
CHARACTERISTICS: | Black | Melting point: | 110 – 150°C (softening point) |
Appearance: | |||
Form: | Fine solid powder | Vapor pressure: | N/a |
Odor: | Odorless | Vapor density: | N/a |
Solubility in Water: | Negligible | Evaporation rate: | N/a |
Specific gravity: | 1.1 – 1.5 | Boiling point: | N/a |
Density: | N/a |
|
|
Section 10: Stability and Reactivity
Conditions to avoid: | None | Materials to avoid: | None | |
Hazardous decomposition products: | Will not occur | Stability: | Stable | |
Polymerization: |
| Will not occur |
|
|
|
|
|
| |
|
| Section 11: Toxicological Information: |
| |
Ames test: | Negative | Acute skin irritation: |
| |
Eye Effects: |
|
|
| |
Acute oral toxicity: LD50 >5000mg/kg |
|
|
| |
Acute inhalation effects: LC50 (4H) is in excess of 5.37 mg/l (this was the highest attainable concentration. |
Special effects: Carcinogenicity: In 1996 the IARC reclassified Carbon Black as a Group 2B carcinogen (possible human carcinogen). This evaluation is given to carbon black for which there is inadequate human evidence, but sufficient animal evidence. The latter is based upon the development of lung tumors in rats receiving chronic inhalation exposures to free carbon black at levels that induce particle overload of the lung. Studies performed in animal models other than rats have not demonstrated an association between carbon black and lung tumors. Moreover,
| Section 12: Environmental / Ecological Information |
Acute toxicity to fish: | LC50 is greater than 1000mg/l (Estimated from the same product) |
Bioaccumulation: | Not known in bioaccumulation |
Persistence/Degradability: | Not known |
Acute toxicity to daphnia: EC50 is greater than 1000mg/l (Estimated from the same product) | |
Algae inhibition test: | Not available |
Information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. On the basis of the data available to us, this product is not a dangerous substance. One should, however, observe the usual precautionary measures for dealing with chemicals.