Lanier G08 manual Material Safety Data Sheet, Accidental Release Measures, Handling and Storage

Models: G08

1 3
Download 3 pages 50.65 Kb
Page 2
Image 2
MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET

Page 2 of 3

CP-771

Section 6: Accidental Release Measures

Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix

AAAToner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue with soap and cold water.

Miscellaneous: Keep product out of sewers and watercourses.

Personal protection: Avoid inhalation of dust.

Section 7: Handling and Storage

Special Handling: Cleanse skin after contact before breaks or meals, and end of workday. Do not handle in areas where the wind blows.

Minimize the breathing of dust.

Special Storage: Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Below 35C (95F)

Section 8: Exposure Control and Personal Protection Information:

Respiratory Protection: none required under normal use.

Eye Protection: none required under normal use.

Hand Protection: none required under normal use.

Skin Protection: none required under normal use.

Section 9: Physical and Chemical Properties

CHARACTERISTICS:

Cyan

Melting point:

N/a

Appearance:

Form:

Powder

Vapor pressure:

N/a

Odor:

Slight plastic odor

Vapor density:

N/a

Solubility in Water:

Insoluble

Evaporation rate:

N/a

Specific gravity:

~ 5 g/cm3

Boiling point:

N/a

 

Section 10: Stability and Reactivity

Conditions to avoid: none

Hazardous decomposition products: will not occur

Polymerization: none

 

 

 

 

Section 11: Toxicological Information:

Ames test: negative

Acute oral toxicity: > 5000mg/kg

Carcinogenicity: no data is available on this product.

Teratogenicity: not available

Section 12: Environmental / Ecological Information

Bioaccumulation: Not known in bioaccumulation

Environmental degradation: not known

Section 13: Disposal Consideration

Used developer should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal regulations vary from locality to locality; therefore consult your local Lanier office or the EPA to determine the proper method for disposal. Do not incinerate loose or spilled developer.

Page 2
Image 2
Lanier G08 Material Safety Data Sheet, Accidental Release Measures, Handling and Storage, Physical and Chemical Properties