Lantronix UDS10, UDS100 Using TFTP

Updating Firmware UDS10/UDS100 User Guide

40

6. Select Do not copy or replace any files and click Next.

Note: This option upgrades the firmware file (.ROM file) only, not

the Web Manager files (.COB).

7. Click Next again. The status of the upgrade shows in the window.

8. After the upgrade completes, click Close.

Using TFTP

If you are running Windows NT or higher, you can simply enter the following

command at the command prompt:

TFTP –i IP address of UDS PUT source file name destination file name

Note: It is easiest to issue the command from the same directory as the one

where the firmware files are.

To download new firmware using a TFTP client:

1. Use a TFTP client to send a binary file (LTX*.ROM for UDS10, DLX*.ROM for

UDS100) to the unit to upgrade the unit's internal operational code, and

CBXW*.cob to upgrade its internal web interface).

Note: TFTP requires the .ROM (binary) version of the unit's internal

operational code.

2. Make sure the Put and Binary options at the top of the window are selected.

3. Enter the full path of the firmware file in the Source File field.

4. In the Destination File field, type of the following:

 3L for the UDS10 or 3D for the UDS100 to load the internal operational code

 WEB6 for the internal web interface.

5. In the Remote Host field, enter the IP address of the unit being upgraded.

6. Click the Put button to transfer the file to the unit.

Contents

Main Copyright & Trademark Contacts Disclaimer & Revisions Contents Page Figures Tables Page Page Page Page Protocol Support Additional Features Configuration Methods Product Information Label Page Required Information Hardware Address IP Address Assigning the IP Address and Related Network Settings DeviceInstaller Serial Port Login Page Page Using Web Manager Example Page Page Using the Serial Port Server Configuration (Network Configuration) IP Address Set Gateway IP Address Netmask Change Telnet configuration password DHCP Naming Change DHCP device name (LTRX) ? (N) Y Enter new DHCP device name : LTRXYES Channel 1 Configuration (Serial Port Settings) Baudrate I/F (Interface) Mode Flow Port Number Connect Mode Manual Connection Page Page Remote IP Address Remote Port Disconnect Mode Flush Mode Pack Control Disconnect Time (Inactivity Timeout) Send Characters Telnet Terminal Type Channel (Port) Password Expert Settings TCP Keepalive time in s ARP Cache timeout in s Security Settings Disable SNMP Page Factory Default Settings Channel 1 Configuration Defaults Expert Settings Defaults Security Settings Defaults Exit Configuration Mode Page Using TFTP Using Another Unit SF x.x.x.x Using the Serial Port Page Page Using Monitor Mode Commands Page Troubleshooting and Contact Information UDS10/UDS100 User Guide 46 Serial LEDs Meaning Problems and Error Messages Notes: diagnostic information sent out the serial port. Problem/Message Reason Solution UDS10/UDS100 User Guide Troubleshooting and Contact Information 47 Problem/Message Reason Solution Troubleshooting and Contact Information UDS10/UDS100 User Guide 48 Problem/Message Reason Solution Technical Support Page Page Page Page Ethernet Connector Pinouts Page UDS100 Technical Specifications Page BOOTP ARP and Telnet Page Scientific Calculator Connect Mode Options Page Page Disconnect Mode Options Page Flush Mode Options UDS10/UDS100 User Guide Binary to Hexadecimal Conversions 67 Flush Mode Options Serial to Network Clear input buffer upon: Network to Serial Clear output buffer upon: Alternate Packing Algorithm Page UDS10/UDS100 User Guide Binary to Hexadecimal Conversions 69 Flush Mode Options Serial to Network Clear input buffer upon: Network to Serial Clear output buffer upon: Alternate Packing Algorithm Page Page Binary to Hexadecimal Conversions UDS10/UDS100 User Guide 72 Interface Mode Options Interface Mode Options Interface Bits Parity Stop Bits Hex Pack Control Options Page Declaration of Conformity Warranty Index