ATDDC4 Series Installation & User’s Guide
5.Slide the circuit board assemblies in partially and secure the required wiring.
6.Slide the circuit board assemblies in fully, then slide the front lenses into place. Note: the inside of the lens has a paper backing which should not be removed. The end with wider paper should go to the right. Replace the end caps and secure each with two Phillips head screws.
7.Discard or store the two original end caps that the modified end caps replaced.
ATDDC4 Series Installation & User’s Guide
Power Connection – Wall Mount
120vAC Electrical Supply can be brought into the ATDDC4 enclosure from any of the six
Note: Optional plastic
.
Power Cord Installation
The optional AC Power Cord Kit (part# VSE0050) includes a 120vAC Power Cord, metal fastener, 2 wire nuts and plastic strain relief that can be installed through any of the available vent holes.
Strip away 1/2" of insulation from each wire of the power cord. Leave eyelet on Ground Wire, if attached.
Remove the vent cap from the selected opening and insert the metal fastener with the tabs toward the inside of the clock. Bend the tabs down and away from the opening to secure it. Feed the cord through, allowing sufficient length to attach the wires; including the ground. Wrap the plastic strain relief around the cord close to the entry point, squeeze it together and insert it into the metal fastener, to secure the power cord to the enclosure.
| Power Cord Installation |
Page 8 | Page 5 |
