Leica 777067-R, 820685, 817857, 790509, 817856, 777069, 777068-R manual Display notices

Checking the accuracy of the vertical plumb en points:

(only Lino P3, Lino P5 and Lino L2P5)

Place the Lock switch 3 in the "Unlocked" ( ) position.

Checking the upper plumb point:

B1	B2 max. 2 mm
	1.5 m
1	2
	A1

Checking the lower plumb point:

	A1
1	2
	1.5 m
B1	B2 max. 2 mm

Set up the laser on its tripod or wall mount bracket near point A1 at a minimum distance of 1.5 m from point B1. The horizontal laser is aligned in direction 1. Mark the laser points A1 and B1 with a pin.

Rotate the instrument by 180° so that it points in the opposite direction 2 to direction 1. Adjust the instru- ment so that the laser beam hits point A1 exactly. If point B2 is no further than 2 mm away from point B1, then the Leica Lino is within tolerance.

Should your Leica Lino be outside of the spec- ified tolerance, please contact an authorised dealer- ship or Leica Geosystems.

Display notices

Falling below or exceeding the permissible temperature range:

The laser switches off and all symbols flash.

Outside of the self-levelling range:

The laser switches off and the symbol of the selected function indicator light starts to flash (for L2), or the line or point will begin to flash on and off and the symbol of the selected function indicator light begins to flash (for P3, P5, L2+, L2G+, and L2P5).

Pendulum locked:

(only Lino L360, L2P5, L2+, L2G+, and L2)

The laser beam is not levelled and the Lock symbol 7 lights up.

Operation

10

Leica Lino 757665i en