OmniSource® SVC – Model BCV636
Universal Charger/Conditioner for 8mm &
PLEASE READ THE INFORMATION AND FOLLOW ALL INSTRUCTIONS THOROUGHLY BEFORE USING THIS PRODUCT.
Introduction
The OmniSource SVC (BCV636) is a fully automatic camcorder battery charger/conditioner which is compatible with almost any 6 volt battery for 8mm and
The BCV636 uses a microprocessor controlled charging circuit which provides a safe, full charge every time. Also,
Flexible power input allows you to use the BCV636 from home with its AC Power Supply or on the road using the DC Cigarette Lighter Adapter included. Avoid prolonged use in an automobile when the engine is not running as it may drain the battery in the vehicle.
Operation:
1.
2.6 volt batteries will slide directly onto the charger unit, making sure the contacts on the battery are aligned with the appropriate contacts on the charger for your camcorder battery type. For 3.6 volt Sharp camcorder batteries, choose the adapter plate for the Li- Ion
3.Once the battery has been properly connected to the charger unit, the Red LED (CHG) indicator will light up to indicate that this unit has begun to charging your battery. When the battery is fully charged, the Red LED will turn off and the Green LED (FULL) indicator will turn on. Remove the battery from the charger.
4.If you wish to condition your battery to eliminate minor memory problems or refresh a stale battery and restore lost capacity, push the button in the lower right hand corner of base unit. The Red LED will go out and the Yellow LED (DIS) will begin to flash while the battery is discharged to the proper voltage. As soon as the battery is properly discharged, the circuit will automatically switch back to charging mode and begin to charge your battery.
Note: Conditioning or fully discharging batteries is recommended ONLY for a
Cautions:
•Do not leave the battery on connected to the charger for prolonged periods (several days). Remove the battery after charge is complete.
•Unplug the charger when not in use.
•Do not use, place or store the charger where it may come into contact with water or moisture.
•Always replace frayed or damaged wire and broken plugs immediately.
•Use this charger with the AC adapter included in the package only.
•It is not necessary or recommended to discharge a
Note: Batteries will self discharge when not in use whether they are attached to a camcorder or not. Batteries can be kept fresh if you do not let them sit idle for more than two months without recharging.
Trouble Shooting Tips:
•If the Red LED (CHG) indicator does not light up when the charger is plugged with power and battery has been attached, the battery contacts may not be touching contacts on base unit. Unplug the unit and check connection of the battery to the charger. If adapter plate is being used, check its connection as well.