Lennox Hearth 290M

P/N 775,290M REV. A 10/2008

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.

Step 5. Using a 3/8” open end wrench, install the front door trim with

the four supplied nuts and washers. DO NOt OVERtIGhtEN thE

NUtS OR SCREwS. See Figure 5.

Step 3. Using a 5/32” allen wrench, attach the louvers above the door

with four supplied screws (two on left side and two on right side

of stove). See Figure 1 on Page 1.

Step 4. Slide the side window trim down into the brackets in the side wall

of the stove. It may be helpful to slightly pry open the brackets

on the stove to slide the side trim in. Be careful to not scratch the

glass or the trim. See Figure 4.

Step 6. Reattach the top of the stove with the four screws.

Step 7. To install the spring handle, ﬁrst close the door and screw the

handle into the receiving nut. Then spray a household glass cleaner

or water on the shaft of the handle to act as a lubricant. Next,

twist the spring handle counterclockwise onto the shaft. Use a

household glass cleaner or alcohol and a soft cloth to remove

any ﬁngerprints from all plated surfaces prior to ﬁring the stove.

Read Caution on Page 1.

Figure 4

Figure 5

Lennox Hearth Products reserves the right to make changes at any time, without notice, in

design, materials, speciﬁcations, prices and also to discontinue colors, styles and products.

Consult your local distributor for ﬁreplace code information.

1110 west taft Avenue • Orange, CA 92865

Figure 6

COMPLEtED

INStALLAtION

Front Door trim

Step 2. Using a 5/32” allen wrench, attach the ash lip to the lower control

door using two supplied screws. See Figure 3.

Figure 3

5/32” Allen wrench