INSTALLATION PROCEDURE
Using a medium Phillips screwdriver and hammer, drive the ash lip end down and away from the holes in the lower frame (Figure 1 ). Both right and left side holes must be clear (Figure 2 ). All BCF, BRF,
Ash Lip
Figure 1
Ash Lip
Screw may be Removed to Provide Room to Adjust
Figure 2
Step 1. Starting with either the right or left door assembly. Engage the hinge pin into the upper frame hole. The roller pin must be posi- tioned within the upper door guide track (Fig- ures 3 and 4 ).
Pivot Pin | Roller Pin |
|
Figure 3
| Upper Door |
|
Hinge Pin | Guide Track | Roller Pin |
Figure 4
Step 2. Lift and swing the lower corner of the door over the hole in the lower frame and engage the shorter hinge pin into this hole (Figures 5 and 6 ).
Lower
Frame
Pivot
Point
Figure 5
Lower Hinge Pin
Figure 6
Step 3. Repeat this procedure for the opposite door assembly.
ADJUSTMENT FOR DOOR ALIGNMENT
The doors are properly adjusted when the top door trim is in a straight, level line and the gap between the doors is even at the top and bot- tom. If adjustments are required, grasp the door handle and loosen the lower door hinge pin using a 3/8" open end wrench*. Slide the door panel on the hinge pin until the gap be- tween the upper door trim and upper frame is even. Retighten the lower door hinge pin*. Repeat this procedure for the opposite door if needed.
*Note: Upper door hinge pins can also be loosened for adjustment purposes; however, it is easier to loosen lower pins.
GENERAL OPERATING PRECAUTIONS AND INSTRUCTIONS
CAUTION: THESE GLASS DOORS ARE LISTED ONLY FOR USE WITH THE SUPE- RIOR FIREPLACE OR APPLIANCE MODELS SHOWN. USE ON ANY OTHER FIREPLACE OR APPLIANCE MAY CONSTITUTE A PO- TENTIAL FIRE HAZARD.
•Avoid building extremely large fires as the tempered glass could become damaged.
•Use fireplace tools carefully to avoid striking the glass.
2 | NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE |