Step 10 Using a 7/16” open-end wrench, loosen pilot stem a quarter of a
turn to the left, counter-clockwise (see Figure 6).
Step 11 Slide the pilot orifice into the NG position by pushing it toward the
opposite side of the pilot stem. The top side of the orifice slider
should appear silver. The gas supply is now lined up with the NG
pilot orifice (See Figure 7).
Step 12 Tighten the pilot stem by turning it back to the right, making sure
the orifice slider stays pushed into the NG position.
Step 13 IMPORTANT: REINSTALL PILOT ShIELD
Step 14 Using a 1/2” open-end wrench, remove burner orifice (see Figure
8). Replace with #30 NG burner orifice using Teflon pipe sealant
or pipe sealing compound.
Step 15 Install burner, and make sure air shutter is 1/8” open. After Step
14, with the appliance lit and fully warmed up, evaluate the burner
flame appearance and re-adjust air shutter for proper flame ap-
pearance, if necessary.
Figure 6
Figure 8
Figure 7
Figure 9 - Air Shutter
Pilot Stem
Pilot hood
7/16” wrench
Slide the pilot
orifice into the NG
position (silver)
Burner Orifice
1/2” End wrench
Open Close
Expanded
View of Air
Shutter Con-
trol Lever
Air Venturi -
Adjust to 1/8” Gap
Air Shutter
Air Shutter
Control Lever
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE. 3