Lennox Hearth 506033-35 instruction sheet

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

FREESTANDING BLOWER SNAp SWITCh RETROFIT KIT

COUNTRY COLLECTION™ WOODSTOVES

p/N 506033-35

Rev. NC, 11/2009

HEARTH PRODUCTS

KITS AND ACCESSORIES

KIT CONTENTS

1 ea. Blower Wire Harness (item #1)

1 ea. Snap Switch and Control Panel Housings (item #2)

1 ea. 6” of 3/4” Heat Shrink Tube (item #3)

2 ea. Butt Connectors (item #4)

3 ea. Wire Ties (item #5)

1 ea. Instruction Sheet

TOOLS NEEDED

5/32 Allen Wrench Or T Handle Wrench

Cutting Pliers

Wire Crimpers

9/16” Socket Wrench

9/16” Open End Wrench

Crescent Wrench

3/8” End Wrench

Large Flat Head Screwdriver

FPO

INSTALLATION INSTRUCTIONS FOR INSTALLING A BLOWER SNAp SWITCh

RETROFIT KIT FOR USE WITh COUNTRY COLLECTION™ MODELS S160, SA160,

SS210, ST210, S260 AND ST310 FREESTANDING WOODSTOVES

WARNINGS

The blower must be plugged directly into a properly

grounded three-prong receptacle, 120 VAC, 60 hz, single

phase. Do not cut or remove the grounding prong from

this plug. Do not route power cord under or in front of

appliance.

Installation must be in accordance with National Elec-

trical Code, ANSI/NFpA 70 - latest edition. In Canada,

the current CSA C22-1 Canadian Electrical Code - latest

edition.

DANGER: Disconnect power before servicing blower.

In the event that you remove the blower for any reason,

make sure a cover plate (available from Lennox hearth

products) is installed before using the heater. Excessive

rear wall temperatures will result if the stove is burned

without the cover plate. The cover plate is not necessary

if a blower has never been installed because a knock-out

will be in place to act as the cover.

FREESTANDING BLOWER SNAp SWITCh RETROFIT KIT

Cat. No. Model Description

h7918 SSK-BLWR-FSB700 Blower Retroﬁt Kit, FS Woodstoves

Figure 1 - Kit Contents

GENERAL INFORMATION

This retroﬁt kit works in conjunction with the optional

700-CFM room air

circulation blower kit. The kit provides a variable speed control (rheostat)

and snap switch, which will allow for the option of automatic thermal

activation of the blower, when desired and blower speed control (see

Blower Operation on Page 8).

If you encounter any problems, need clariﬁcation of these instructions or

are not qualiﬁed to properly install this kit, contact your local distributor

or dealer.

Read this instruction sheet in its entirety before beginning the installa-

tion.

ALL WARNINGS AND pRECAUTIONS IN ThE INSTALLATION AND

OpERATION MANUAL pROVIDED WITh ThE AppLIANCE AppLY TO

ThESE INSTRUCTIONS.

ShUT DOWN ThE STOVE AND ALLOW IT TO COMpLETELY COOL BEFORE

pROCEEDING.