Lennox Hearth 506033-35 Figure 17, Figure 18, Figure 22, Figure 21, Figure 19, Figure 20

5
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Step 4. While holding the snap switch bracket against the pedestal, slide
the bracket towards the rear of the stove until it comes to a stop.
Once the snap switch bracket is in place you can then remove the
flat head screwdriver or pry bar that was used to create the opening
between the firebox bottom and pedestal. See Figure 18.
Step 5. With the snap switch bracket in place, using a 9/16” wrench or
socket wrench you can now tighten down both left and right side
pedestal bolts. See Figure 19.
Step 6. Locate the 3/8” diameter x 1/2” long bolt on the bottom of the
firebox near the draft handle. Using a 9/16” wrench or socket
loosen this bolt but do not remove from threaded hole. See
Figure 20. Note: This bolt was holding the stoves shipping legs
on the stove and should have been reinstalled with the other
three bolts that were holding the shipping legs on the stove per
the pedestal instructions.
Step 7. Locate front slot on the control box as shown in Figure 21.
Figure 17
Figure 18
Figure 19
Figure 20
Figure 21
Bolt
Draft handle
Slot
Snap Switch
Bracket Tabs
Snap Switch
housing
Tighten Left
and Right
pedestal Bolts
Step 8. Install the control box by sliding the front control box slot over the
3/8” bolt head from Step 6. Slide control box towards the center
of the stove until it stops on the tabs. See Figure 22.
Figure 22
Tabs