1

AIR CIRCULATION BLOWER kIT

MODEL VINT-TET BLWR, CAT. NO. 75194

INSTALLATION INSTRUCTIONS FOR AN AIR CIRCULATION BLOWER kIT FOR USE WITh ThE VINTAGE™ 27 GAS STOVE
775202M
Rev. A, 01/2011
LENNOX HEARTH PRODUCTSKITS AND ACCESSORIES

kIT CONTENTS

1 ea. Blower Assembly (item #1)
2 ea. Washers, #10 (item #2)
2 ea. Nuts, 10-24 Nylock (item #3)
1 ea. Instruction Sheet
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
TURN OFF ThE STOVE AND ALLOW IT TO COMPLETELY COOL BEFORE
PROCEEDING.

INSTALLATION INSTRUCTIONS

Step 1. Using an allen wrench, remove socket head screw A that secures the
heat shield to the bottom of the stove. See Figure 2.
Step 2. Using pliers, twist and break off section B of the heat shield (shown
as hatched section B in Figure 2). Discard this piece after removing.

Figure 1 - Kit Contents

Figure 2

TOOLS NEEDED

5/32” Allen Wrench Or T-Handle Wrench
3/8” End Wrench
Pliers

GENERAL INFORMATION

This optional 150-CFM blower for the Vintage gas stove provides variable
speed control, thermal activation and forced air circulation of the warm air
into the room.
If you encounter any problems, need clarification of these instructions or are
not qualified to properly install this kit, contact you local distributor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
ALL WARNINGS AND PRECAUTIONS IN ThE INSTALLATION AND OPERA-
TION MANUAL PROVIDED WITh ThE APPLIANCE APPLY TO ThESE
INSTRUCTIONS.
A
B
heat Shield
Stove Bottom
Stove Back
A
B
B
1
2
3
2. Remove Section B
and Discard
1. Remove
Screw A