24
RATING LABELS
MANUFACTURED AT: AUBURN, WASHINGTONFOR USE WITH NATURAL GAS. EQUIPE POUR GAZ NATURELALTITUDEMIN. GAS SUPPLY PRESS (“WC)PRESS MIN. D’ALIMENTATION (“CE)MANIFOLD PRESSURE (“WC)PRESSION CE TUBULURE (“CE)MANUFACTURER’S RECOMMENDED ORIFICE SIZEDIMENSION DE L’INJECTEUR RECOMMANDE PAR MANUFACTURIER (DMS)MAX INPUT (BTUH) ENTRÉE MAX (BTUH) MIN INPUT (BTUH)ENTRÉE MIN (BTUH) 0-4500 FT (0-1370 M) 4.5”3.5”#3728,00017,500
ELECTRICAL RATING/EXIGENCES ELECTRIQUES:
OPTIONAL FAN/SOUFFLEUR OPTIONAL
-UNIT/APPAREIL: MILLIVOLT
1 ph
60 HZ
120 VOLTS
LESS THAN 5 AMPS
MINIMUM SIDEWALLS
FLOOR
2”
0”
CLEARANCES TO CEILING OR ALCOVE HEIGHT
BACK/CORNER 45q
62”
4”
COMBUSTIBLE
MATERIAL
VENT SURFACES: TOP
SIDES
BOTTOM
3”
1”
1”
ALCOVE MAXIMUM DEPTH 48”
DEGAGEMENT MURADJACENTS
PLANCHER
50.8mm
0mm
MINIMUM DE PLAFOND OU HAUTEUR D'ALCÔVE
EN ARRIÈRE ET COIN 45 ANGLE
1574.8mm
101.6mm
MATERIAUX
COMBUSTIBLES
SURFACES D’AERATION: DESSUS
COTES
BAS
76.2mm
25.4mm
25.4mm
PROFONDEUR D'ALCÔVE MAXIMALE 1219.2mm
DIRECT VENT GAS STOVE / APPAREIL A GAZ AVEC EVACUATION DIRECTE
VENTED GAS STOVE HEATER – NOT FOR USE WITH SOLID FUEL.
FOYER DE CHAUFFAGE AU GAZ A EVACUATION - NE DOIT PAS ETRE UTILISE AVEC UN
COMBUSTIBLE SOLIDE.
FOR USE WITH GLASS DOOR CERTIFIED WITH THE APPLIANCE ONLY.
N’UTILISER SEULEMENT QUE LA PORTE DE VERRE CERTIFIE AVEC L’APPAREIL.
“CAUTION:Do not operate the appliance with glass removed, cracked or broken.
Replacement of panel should be done by a licensed or qualified service person.”“This appliance is equipped at the factory for use with natural gas only. Units using propane must be field converted using the LP conversion kit, P/NH3705”
INAL INSPECTION BY:
ANSI Z21.88-2007CSA 2.33-2007CAN/CGA-2.17-M91VENTED GAS STOVE HEATERS FOYER DE CHAUFFAGE AU GAZ A EVACUATION P/N 9-1452ASERIAL NUMBER/NOMBRE DE SERIE XXXXX XXXXX

IIIIIIIIIIIIIIIIIIII

XXXXXXXXXXXXXXXXP/N 9-1452A DO NOT SCALE THIS PRINT THIS PRINT IS THE PROPERTY OF LENNOX INDUSTRIES CALTNO. DATE ALTERATIONS ENGR& CHKR 6/17/03 ECN T-2549: INITIAL RELEASE DM1 6/24/03 T-2185: MODEL WAS CI1500DVF DM2 7/11/03 T-2559: ADD ALCOVE IN NOTES AND DEPTH-48”LB3 5/23/05 T-3125: UPDATE LENNOX LOGO & MANUFACTURED AT. JSH4 9/8/06 T-3414; REVISED MFR’D AT DM5 5/18/07 T-3531; REVISED MFR’D AT DM
TOLERANCE UNLESS OTHERWISE NOTED LINEAL DIM., SQUARENESS, NOTCH &
BRAKE RES. ± 1/32 ANGLES ±2°, HOLES UP TO ¼” ±.004, ¼” ±.005, ¼” TO 1” ±.010, OVER
1” ±1/64
LENNOX®Industries Inc. ENGINEERING
DEPT.
TORONTO,
ONTARIO
DESIGN OF STICKER - RATING PLATE MATERIAL SEE ABOVE
FOR FINISH SECS REFER TO ES-0049
PAINT
INSIDE NONE SHEET NO.
1 OF 1
DWG
NO.
PAINT
OUTSIDE NONE 9-1452A
MATERIAL: 24M8501 QTY 1
299008016, QTY 1.021 FEET
MODEL NO.
CI1500DVF
SERIES
MANUFACTUREDAT: AUBURN, WASHINGTONFORUSE WITH NATURAL GAS. EQUIPE POUR GAZ NATURELALTITUDEMIN.GAS SUPPLY PRESS (“WC)PRESSMIN. D’ALIMENTATION (“CE)MANIFOLDPRESSURE (“WC)PRESSIONCE TUBULURE (“CE)MANUFACTURER’SRECOMMENDED ORIFICE SIZEDIMENSIONDE L’INJECTEUR RECOMMANDE PARMANUFACTURIER(DMS)MAXINPUT (BTUH)ENTRÉEMAX (BTUH)MININPUT (BTUH)ENTRÉEMIN (BTUH)0-4500FT (0-1370 M)4.5”3.5”.12138,50025,500
ELECTRICAL RATING/EXIGENCES ELECTRIQUES:
OPTIONALFAN/SOUFFLEUR OPTIONAL
-UNIT/APPAREIL: MILLIVOLT
1ph
60HZ
120VOLTS
LESSTHAN 5 AMPS
MINI SMUM IDEWALLS
FLOOR
2”
0”
CLEARANCES TO CEILING OR ALCOVE HEIGHT
BACK/CORNER45°
62”
4”
COMBUSTIBLE
MATERIAL
VENT SURFACES: TOP
SIDES
BOTTOM
3”
1”
1”
ALCOVEMAXIMUM DEPTH 48”
DEGAGEMENT MURADJACENTS
PLANCHER
50.8mm
0mm
MINIMUMDE PLAFOND OU HAUTEUR D'ALCÔVE
EN ARRIÈRE ET COIN 45 ANGLE
1574.8mm
101.6mm
MATERIAUX
COMBUSTIBLES
SURFACES D’AERATION: DESSUS
COTES
BAS
76.2mm
25.4mm
25.4mm
PROFONDEURD'ALCÔVE MAXIMALE 1219.2mm
DIRECT VENT GAS STOVE / APPAREIL A GAZ AVEC EVACUATION DIRECTE
VENTED GAS STOVE HEATER – NOTFOR USE WITH SOLID FUEL.
FOYER DE CHAUFFAGE AU GAZ A EVACUATION- NE DOIT PAS ETRE UTILISE AVEC UN
COMBUSTIBLE SOLIDE.
FOR USE WITH GLASS DOOR CERTIFIED WITH THE APPLIANCE ONLY.
N’UTILISER SEULEMENT QUE LA PORTEDE VERRE CERTIFIE AVEC L’APPAREIL.
“CAUTION:Do not operate the appliance with glass removed, cracked or broken.
Replacementof panel should be done by a licensed or qualified service person.” .”“Thisappliance is equipped at the factory for use with natural gas only. Units usingpropanemust be field converted using the LP conversion kit, P/N H3706”
FINAL INSPECTIONBY:
ANSIZ21.88-2007CSA2.33-2007CAN/CGA-2.17-M91VENTEDGAS STOVE HEATERSFOYERDE CHAUFFAGE AU GAZ A EVACUATION P/N 9-1452FSERIAL NUMBER/NOMBRE DE SERIE
XXXXX XXXXX
IIIIIIIIIIIIIIIIIIIIXXXXXXXXXXXXXXXXP/N 9-1452FDO NOT SCALE THIS PRINT THIS PRINT IS THE PROPERTY OF LENNOX INDUSTRIES INC.

MODEL NO.

CI2500DVF

SERIES

MATERIAL: 24M8501 QTY 1

299008016, QTY 1.021 FEET

A
LTNO. DATE
A
LTERATIONS ENGR
&CHKR6/17/03 ECNT-2549: INITIAL RELEASE DM1 6/24/03 T-2185:MODEL W AS CI2500DVF DM2 7/11/03 T-2556:ADD ALCOVE IN NOTES ANDDEPTH-48”LB3 5/23/05 T-3125:UPDATE LENNOX LOGO &MANUFACTUREDAT.JSH4 9/8/06 T-3414;REVISED MFR’D AT DM5 5/18/07 T-3531;REVISED M FR’D AT DM
TOLERANCE UNLESS OTHERWISE NOTED LINEAL DIM., SQUARENESS, NOTCH &
BRAKERES. ± 1/32 ANGLES ±2°, HOLES UP TO ¼” ±.004, ¼” ±.005, ¼” TO 1” ±.010, OVER
1”±1/64
LENNOX®Ind u s t r i e s I n c . ENGIN E E R I N G
DEPT.
TORONTO,
ONTARIO
DESIGN OF STICKER - RATING PLATE MATERIAL SEE ABOVE
FOR FINISH SECS REFER TO ES-0049
PAINT
INSIDE NONE SHEET NO.
1 OF1
DWG
NO.
PAINT
OUTSIDE NONE 9-1452F
USPortland
USPortland